The R/E ratio, or "retention ratio," is a financial metric that indicates the percentage of a company's earnings that is retained (not paid out as dividends) and reinvested back into the company for growth. It is calculated as (1 - dividend payout ratio) and can help investors assess how much of a company's profits are being plowed back into the business. A high R/E ratio suggests strong growth potential, while a low ratio may indicate that the company is distributing most of its profits to shareholders.
Ohm's Law Voltage = Current x Resistance
;kljkihkj\ ,loklkl nmkjk klk;l ;[]lp[l lpl[ o[lp[ olp[lp yttr t tt trrr r r r r r r r r r r r r r rtrereer e e e e ee e ee e e e e e e e e e e e e e e e e e e e e
No. A higher P E ratio can result in much better results than a lower P E ratio, but it is a lot riskier. Meaning a higher risk of loss for the higher P E ratio.
V = I * RThe equation you are looking for is R = V/I, although this is derived from the definition of the ohm, not Ohm's Law!Ohm's Law is merely a statement which, in effect, says that for a limited range of conductors, the ratio of voltage to current is constant for variations in voltage.If the ratio of voltage to current changes for variations in voltage, then Ohm's Law does not apply.However, the ratio of voltage to current will always tell you what the resistance of a load or device happens to be for that particular ratio.
x/r ratio is reactance/resistance where reactance is impedance * frequency (60 hz)
its a S E G E R its a S E G E R its a S E G E R its a S E G E R
the simplified ratio is 4:5
I=E/R You need to multiply both sides by R to get the R to reduce out of the right side. I*R=E
It is a*r^4 where a is the first term and r is the common ratio (the ratio between a term and the one before it).
The ratio between radius of proton to the radius of electron is just 0.3
It is 3:1. This is because volume of a cone is pi/3*r*r*h while vol of a cylinder is pi*r*r*h.
The formula for resistance (R) is R = E/I, where E is the voltage and I is the current flowing through the circuit.