answersLogoWhite

0

What else can I help you with?

Related Questions

How do you fix a hole in a leather boot?

by gluing with super glue or Elmer's glue


How can I fix a stripped wood screw hole?

To fix a stripped wood screw hole, you can fill it with a wooden dowel or toothpicks coated in wood glue. Once the glue dries, you can reinsert the screw into the hole.


What is hole out in golf?

Hole out is simply finishing a hole of golf, obviously by putting the ball in the hole.


How can I fix a screw hole that is too big in wood?

To fix a screw hole that is too big in wood, you can fill the hole with a wooden dowel or toothpicks dipped in wood glue. Once the glue dries, you can re-drill a smaller hole and insert the screw.


Is water stronger than glue?

water is not stronger then glue because water can break a hole house down.


What putting drills does Tiger Woods do?

Practice putting the ball in the hole. He did this his entire life.


How can I create a strong and durable joint using pocket hole screws in MDF?

To create a strong and durable joint using pocket hole screws in MDF, follow these steps: Use a pocket hole jig to drill holes at an angle into the MDF pieces. Apply wood glue to the joint before inserting the screws. Use the appropriate length of pocket hole screws to secure the pieces together. Make sure the screws are tightened securely to create a strong bond. Allow the glue to dry completely before putting any stress on the joint.


What kind of glue can i use to put rhinestones on real flowers?

Probably superglue, because a hot glue gun will probably make a hole.


How do you fix a bed?

i would get a new one or if its a hole glue it or get a patching kit


Why is the flag sometimes left in the hole when a player is putting?

no


How can I use wood glue to fill screw holes effectively?

To use wood glue to fill screw holes effectively, first remove any debris from the hole. Then, apply a small amount of wood glue into the hole and use a putty knife to smooth it out. Allow the glue to dry completely before sanding it down to create a smooth finish.


Can you glue the gear shift button back on?

I doubt it . I would make it fit mechanically first, drill a hole or something, then glue it with a good epoxy.