The clamp on a pulley looks like a shackle that you see on the end of a chain if the pulley is stainless steel with a clamp on it you can use for flagpoles if there is a hole at the top of the pole that is what the clamp on the pulley is for to clamp it into place it will never rust or fall off whatever rope you use make sure it has lasting longevity and it won't snap or break
I have changed the water pump on several engines that use that pump, and I never needed or used a clamp. The only possible use that comes to mind would be to clamp on the pulley to keep it from turning so the bolts that hold the pulley on could be taken out. You have to take the pulley off to get to the bolts that hold the water pump in place. The replacement pumps I used did not come with a new pulley so the old one had to be reused.
the answer was the bench pulley is use with the force table together with a string. fhil ricard alumno of biñan-"bench pulley" -this vertical table clamp pulley consists of a 4cm plastic pulley mounted on a table clamp with low friction brass cone bearings. It can be used on lab tables or inclined boards for experiments involving the resolution of forces, friction, motion, etc. It can clamp onto surfaces up to 3cm thick. a crosspiece on the screw offers more gripping force and the felt padding inside the clamp protects table surfaces.
to clamp the buret
Use a puller. there are two holes on the in side of the pulley. I had to clamp the sides to the pully to the puller, the holes just stripped out. U could drill and re tap the holes to match the bolts on the puller.
pulley for what?
the use of clamp is science is : Doctor Simon says that they are healthy.
To clamp one in to keep it right up.
To remove a PEX clamp, use a clamp removal tool or a pair of pliers to squeeze the tabs on the clamp together, then slide the clamp off the PEX tubing.
Fixed Pulley and Compound Pulley.
To remove a pulley, you typically need to use a pulley puller tool. First, release tension on the belt connected to the pulley. Then, follow the specific instructions for your vehicle or equipment to use the pulley puller to gently remove the pulley without damaging surrounding components.
You need to pick up a pulley puller tool ($25) from an auto parts store. Clamp it on the small flange then brace the puller so it doesn't turn and then tighten the large bolt and the pulley will be pried off.
It would depend on what you want to use the belt and pulley for