0
Silent Reading: Merits: Allows for faster reading speed and increased focus without the distractions of external noise. Demerits: Lack of vocalization may lead to reduced comprehension for some individuals, as they may struggle to engage with the material at a deeper level.
Loud Reading: Merits: Can aid in improving pronunciation, fluency, and overall understanding of the material through auditory reinforcement. Demerits: May be disruptive to others, slower than silent reading, and not always feasible in certain environments.
What else can I help you with?
What are merits and demerits of transformer connected in parallel?
Followings are merits and demerits of parallel operations of transformers: Merits 1. Increasing load demand on substation can meet by connecting transformers in parallel. 2. Maintenance of individual transformer with low rating (Instead of one Big transformer with high rating)becomes easy and can be done without affecting power supply. 3. In case of any fault, faulty transformer can be removed from the system and others may continue feeding the load. 4. Power reliability of substation is increased. Demerits 1.Parallel operation needs very much attention and correctness. 2.Phase sequence , Voltage Ratings , % impedance drop and polarities these few things comes in picture which needs to be taken care when doing parallel operation.
What are two merits of railways?
Speed Load Capacity
Can anyone hear your thoughts?
No, thoughts a silent, unless you think out load.
What is the diesel consumption of kirloskar silent generator 25kva?
6.3 liters/hour at full load
What is a good or bad specific gravity reading on a load of aviation fuel What specific gravity reading should I be looking for on a new load out of a tanker?
depends on the type of aviation fuel, need more info
Why does the voltage reading of 110 circuit is less than expected?
A load or a resistance
Why wattmeter shows negative reading during no load condition of 3phase ac induction motor?
no load means the motor is acting like a coil
Will the reading of the load cell differ from the above if it is placed at 100mm from the center of the cross section?
Yes, the reading on the load cell will differ compared to when it is placed at the center of the cross-section. Placing the load cell 100mm away from the center will result in a different moment arm, leading to a different torque measurement and potentially affecting the reading depending on the specific setup and application.
Can you read 120 volts line to neutral even with a severed neutral?
It depends on what side of the break that you are reading from. On the neutral load side of the break there will be no reading. On the panel neutral side of the break you will get a reading.
Why it is essential for voltmeters to have a very high resistance?
if the resistance of the meter is low that will act as a parallel load effecting the reading. If the meter can be made with infinite resistance then the meter will not effects the actual reading.
What is loading effect?
An instrument to be able to really tell the value is mandatory that the instrument does not load the circuit making it a false reading or inaccurate loading effect which means when we give high load that may be cause to some fake or inaccurate of output, this may be known as loading effect....
What are the merits and demerits of waterways?
Advantages:Cheapest traffic meansMost important in security of nationPlays important role in international trade.Possesses high load carrying capacity.Requires cheap motor powers than for airplanes.Does not require any special infrastructure like roads, and airports.Brings many countries together.Drawbacks:Slow in speedMore chances of attack on boat sailing throughOnly can be used when sufficient water is available.In deep sea if boat gets in to storm, it becomes difficult to rescue.In waterfalls having much drafts ,water transportation does not works.Special maintenance for water tightness of boat is required.
