answersLogoWhite

0

You need a step-up transformer, to go from 110 to 220-240 volts. Then a 110 volt supply can operate 240 volt equipment.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Can an espresso machine with a 20A 240V Leviton plug be powered without rewiring?

You need a dedicated circuit for that. You cannot power a 220V device off 110V.


Do Indian electrical devices work in US?

No India uses 240V at 50Hz the U.S. uses 110V at 60Hz.


How do you convert a 240v drill to 110v?

One word: KABOOM.


How can I charge my devices on-the-go with a 240V power bank?

To charge your devices on-the-go with a 240V power bank, you can use a power inverter that converts the power from the power bank to the appropriate voltage for your devices. Make sure to check the power requirements of your devices and use a compatible power inverter to avoid damaging them.


Can 240v coil contactor be connected to 110v supply?

no


Can you power a 110V power tool with a 240V plug?

If 240 power is supplied you can. Depends on power pole.


Can you plug a American laptop into England?

Check your laptops power adapter to see if it will handle both 240v(UK) and 110v(US) if it can handle 240v (which I believe most can) then all you need is a UK plug adapter.


240v box outside for a hot tub you need a 110v receptacle Can you wire it off the 240v box?

Using a box that is hire voltage than what you need can cause a short, and even a fire. So using a 240V box, when all you need is a 110v receptacle, wouldn't be a good idea.


What kind of fuse need to use for 240V outlet?

For a 240V outlet, you should use a fuse that is rated for 240V. The fuse's amperage rating should match the amp rating of the circuit and be appropriate for the connected devices. It's important to use the correct type and rating of fuse to protect the circuit from overloading and electrical hazards.


Can you replace the 240v plug on my 240v mitre saw with a 110v plug and run it off a 110v transformer?

Changing the plug will not change the power needed to run the saw. If the saw has a dual voltage motor then a wiring change can be done to switch the saw from 240 to 110 volts. If it is not a dual voltage system then the saw must be fed with 220 volts.


Can a 240V - 110V stepdown transformer be reversed to take a primary load of 180V to secondary 240Volts?

No


Do you need a neutral when running a BLK Red and ground from a panel directly to a 240V 4800W 20A heater outlet?

No. The black is 220, the red is 220, and the ground serves as the neutral. the last answer "no" is correct but the reason is not. the ground is still a ground. the red is 110v and the black is 110v. together they are 220v. the neutral or (common) is for a 110v return. for example a stove or a dryer will have 2 hots a common and a ground because they use 220v and 110v. 220v to power the heating elements and 110 for the controls, light bulbs or the outlet on a stove. A construction heater only uses 220v and only requires the two hots and the ground for safety.