Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.
Without knowing the wattage that the hair dryer is rated at an amperage can not be stated. If you find the wattage, use this equation to find the amperage. I = W/E, Amps = Watts/Volts.
Because a toaster does not pull near the current that a cloths dryer does.
Because a toaster does not pull near the current that a cloths dryer does.
I work At sears the highest BTU's we have is 15,000 that will use 110 outlet
If you are close to a 110 power outlet plug in a hair dryer and warm the area up for a while. If not, you can purchase a spray from your local auto parts store that will defrost the lock and lubricate it at the same time.
It depends on what kind of dryer you are going to put in though I recommend to put in a 110 dryer so there will be no need for a contractor as the outlet for your washer is usually rated to supply enough amps for both appliances.
Yes, you can use a 110-watt outlet for 117 volts, as the outlet is designed to handle a range of voltages, typically between 110 to 120 volts. The wattage rating indicates the maximum power the outlet can provide, so as long as the device you are plugging in does not exceed that wattage, it should work safely. However, ensure that the total load does not exceed the outlet's capacity to prevent overheating or tripping the circuit.
Well honey, the cubic foot capacity of a Kenmore dryer model 110 can vary depending on the specific model. You can typically find this information in the product manual or by checking the sticker inside the dryer door. So go ahead and do a little detective work, and you'll have your answer in no time.
Nominally 110 to 120 volt power strip is okay to connect to a standard outlet.
Yes, it is possible to convert a dryer outlet into two separate circuits by rewiring and adding a new breaker for the second circuit. However, it's important to ensure that the electrical load and wiring capacity can accommodate the additional circuit to prevent overloading the system and ensuring safety. Consulting with a qualified electrician is recommended for this type of project.
no, you'll probably get electrocuted
no