Sometimes you can't do it yourself. It takes a special tool that only a jeweler has. Turn over the back and if it has little notches that takes a special tool. If it is flat you maybe able to pry it off. There should be a little indentation along the edge. Take a small jewelry screwdriver and pry the back off on that indention. If that doesn't come off right away I would take it to a jeweler before you ruin the watch. Some watches aren't worth getting a battery. Just get a new watch.
To set the compass on your Timex Expedition E-Tide Temp watch, press the mode button until you reach the compass mode. Next, rotate the watch horizontally a few times to calibrate the compass. Once calibrated, point the watch's 12 o'clock position towards the North to use the compass feature.
To set the time on your Timex tide temp watch, press and hold the "mode" button until the time digits start flashing. Use the "advance" and "select" buttons to adjust the hours, minutes, and date. To set the tide and temperature functions, refer to the user manual which can guide you through the specific steps.
Skyscan Atomic Clock Model 86722ALU needs a reset after a battery change, or needs a battery change.
Never heard of Battery Temp Sensors. What exactly is the code #?
To keep ur battery at the right temp..
To change the temp display from F to C or vice versa (like when the battery is disconnected) you press the Temp down arrow & the Amb buttons for about 5 seconds. Then the display will change. Hope you still need this & it helps. Happy New Year, CT Toolman.
it has many temp because it can be changed by a reaction of the change in temp
On my 1999 Jeep Wrangler the batt. temp sensor is underneath the battery and mounted to the batt. base plate through a hole in the plate.
On the timex E tide, the crown has two positions, when you pull it out. The first position is for setting the tide. Pull the crown out to the first position and you should hear a small beep and the tide/temp hand will move to the 12 and 6 o'clock position. The red end of the hand should be at he 12 o'clock position, by default; this is the indicating end of the hand (for temp and tide). Now, use the buttons above or below the crown button to move the red end of the hand left or right around the dial, to the current tide. Once you have that set, push in the crown and check the tide. Push the button below the crown (tide button) and the tide/temp hand should move round to the tide time, you just set (with the red end of the hand marking the tide time)
under the battery tray...it mounts right at the center in a little cutout
i change the thermostat and the temp switch but still not working
Change in temp=final temp-initial temp, so -5-15=-20 lrn to math