This is from the Sentry Web Site:
How do I insert the batteries on my standard electronic lock?
To power the lock, four alkaline AA batteries, are required.
To install batteries:
· slide open the battery cover located just below the keypad.
· Insert a paper clip or pen point into the small hole in the cover.
· Push in while sliding cover to the right.
· Disconnect and remove the battery holder.
· Insert the 4-batteries as indicated.
· reconnect the connector and put back the battery holder.
· Slide the cover back in place.
Contact Sentry or a qualified locksmith.
You will need to contact Sentry or a good locksmith.
forgot combination to my sentry valueguard 1380. Pls help
have code need to change
In a Sentry Safe, the batteries are typically located in the electronic lock compartment. To access the battery compartment, you usually need to open the safe using the key or enter the correct code. Once open, you can find the battery slot, which may require a screwdriver to remove a cover. Always refer to the specific model's manual for detailed instructions on battery replacement.
The Sentry G5241 14 gun safe weighs 170 lbs (according to the Sentry website)
To find the serial number on a Sentry Safe, look for a sticker or metal plate, typically located on the back, bottom, or inside the door of the safe. The serial number is usually printed alongside other information like the model number. If it's a digital safe, you might also check inside the battery compartment. If you're unable to locate it, consult the user manual or Sentry Safe's customer support for assistance.
Thia all depends on which code you are trying to change. The digital electronic code that comes with the safes can not be changed. what you need to do is program a user code into the sentry safe which can be re programed by the safe owner's. This is the only code you want to give out as only the user code can be changed. please follow this link for Sentry Safe programing instructions. Just scroll to the middle of the page on this page http://www.a1qualitysafe.com/page/212853
contact sentry safe company give them the serial number model number and they should be able to give you the default number but this will only help if you didn't change the lock combonation.
To remove the keypad from a V360 safe, first ensure the safe is powered off and disconnected from any power source. Use a screwdriver to remove the screws securing the keypad to the front panel. Once the screws are removed, gently pull the keypad away from the safe, being cautious of any wiring connected to it. If necessary, disconnect the wiring harness before completely detaching the keypad.
If you have the SN (usuall a small sticker on safe) you can write to Sentry and they will send you the combination with the proper paper work.
If you have the model and serial number you can write to Sentry Safe and they will give you the combination for a fee. The other option is to call a locksmith out, but they will drill the safe and cause damage beyond repair.