The peak of any graph is the highest point (usually in the y direction). The peak is the maximum value.
Perhaps the graph was about the height of the hour hand of a clock!
The peak in the graph line at 12 p.m. is likely caused by a significant increase in activity or demand during that time. This could be due to various factors, such as peak usage hours for a service, lunch breaks leading to increased consumer behavior, or specific events occurring at that time. Analyzing the context of the data can provide more insights into the exact cause.
Peak height refers to the tallest recorded measure a person will be. After you grow in height with age, you will eventually stop. However, as aging continues and our bones and muscle weaken, we begin to lose height. So the peak height refers to the tallest a person will grow to become, regardless of how much height they end up losing later on in life.
No, not all distributions are symmetrical, and not all distributions have a single peak.
The classic example is a Bell curve. IQ testing (using the WAIS, or Wechsler Adult Intelligence Scale) yields a peak at the 100-105 IQ mark, with a downward curve on either side of the peak - representing the higher and lower IQ scores, respectively.
It is a measure of the spectral heterogeniety of a peak based on the comparison of spectra over all the peak, using the spectral contrast angle.
which line of longitude runs near pikes peak Colorado
the peak
Use those speacial reading graphs You should have a hydrograph to look at. Look at the curve on this graph, the highest point on this curve is the peak flow. It cannot be calculated, just read off a graph. Peak Flow = Tidal Volume x 60 / I-time
peak - peak.
The usual opposite (especially in graphs) is a peak. (crest, apex, summit)But for a geographic valley, it is not necessarily the lowest point, so opposites could be either hill or mountain.
Peak - neutral for 120 volts RMS is 169 volts, or 120 * sqrt(2) Peak to peak will be 2 x this value, or 339 volts.
i mean spurt
When the mist cleared I was able to take a peek and the peak of the mountain.
A: AC or our line voltage is sinusoidal in nature it goes up to a positive peak returns to zero and proceed to the negative peak. 120V AC is actually swinging from peak to peak. It is 120 volts but the peak is the 120 v times 1.41 or 169.2 volts and since it also go negative then the peak to peak 120 volts times 2.82 or 338.40 volts or twice the peak voltage
Peak force can be calculated by dividing the peak load (the maximum force experienced during the movement) by the area over which the force is distributed. This can be determined by using a force sensor or load cell to measure the force and then calculating the peak force using the formula: Peak force = Peak load / Area.
Based on the graphs showing the distribution of heights among people in four different countries, the country with the tallest people can be determined by looking at the graph with the highest peak or median height. The country whose graph shows the highest peak or median height generally has the tallest people on average.