Teflon

yes,as you do in case of joints in ro plants.

Use the yellow tape. Its specifically for gas. I also use a small amount of pipe dope on the female fittings. Pressure test the new work separately, or if its a small add on use a soap solution to test your work.

hey I'm Melissa Brittany's sister i am not sure where it is but i can give it to you:

heart of Teflon cold as stone

built up from the years of being alone

layer upon layer until there was no room

i no longer hear Jesus trying to get through

he called out my name but i did not reply

i was unaware of the time that was just passing by

i felt like this was it it was done for me

but i knew in my heart i wanted to be free

layer upon layer he chiseled away

by the love and acceptance shown each day

instead of a heart of Teflon cold as stone

i have a new life

new family and new home.

Brittany whiles

that's my sisters poem i hope you can use it.

Thanks little sis for answering her question. I appreciate it.

Yes the non stick stainless steel is similar to teflon . Teflon is usually a layer coat in pans whereas non stick stainless steel is adapted altogather. Non stick stainless steel is also a bit more hard waring .

Teflon is made of polytetrafluoroethylene (PTFE), which can release toxic fumes when overheated. Ingesting large amounts of Teflon can cause flu-like symptoms due to the release of toxic gases like perfluorooctanoic acid (PFOA). Over time, PFOA has been associated with health issues like cancer and developmental problems.

Teflon is a nonstick coating often applied to cookware, while aluminum is a metal commonly used in cookware construction for its heat conductivity. Teflon provides a nonstick surface, while aluminum helps in even heat distribution. Teflon is also known for being scratch-resistant, while aluminum can react with acidic foods if not properly coated.

yes

Due to high electro egative flourine atoms

Most likely not. If the sensor reads hot it will short to ground through its casing and trip the warning signal. The tape can prevent it from reaching ground.

From this web site, they say there's will go from -450f to +550F.

http://www.sealfast.com/d_teflon_tape.html

A Gecko cannot stick to Polytetrafluoroethylene (a.k.a. Teflon) due to the plastics resistance to Van Der Waals forces The oil will disrupt the vander waals force that allows a gecko to climb. Plastic is made from oil. Why do gecko's feet stick so well? The the vander waals force unique form by seta, tiny hairs that have spatula shaped tips. Water increase this power and oil will stop it. I saw a gecko slip on a human leg and couldn't believe it. Must of had oily skin?

Teflon is inert to gasoline and all petroleum products. The problem with Teflon is it cold flows under pressure so that when tightened (when wrapped around your fitting) it will relax eventually and probably not seal properly. This is not something you want where gasoline can leak.

I believe around the 1970's

There are approved Teflon tapes for "gas" but it depends on the HJA and what type of "gas" your asking about