How do you make an airsoft bazooka?

Answer 1

It is simple but it will cost you probaly about $15.( I got it all from ACE Hardware)

Here's what you need:

a 1.5 Plastic Ball Valve

4.5 feet of 1.5 PVC pipe(get it cut into 2 feet and 2.5 feet)

some Cold Weld and PVC Glue

a Bike Pump valve

and a 1.5 end cap for the PVC

Steps

1-drill a hole in the end cap

2-glue the bike pump valve to the hole and go around it with cold weld

3-cold weld and glue around the edge of the end cup and stick it onto one end of the bigger PVC(make sure it is air tight)

4-glue around the sides and edges of the PVC with the end cup

5-make sure that it is air tight with cold weld

6-glue it into the valve( AIRTIGHT!!!!with cold weld)

7-put glue around the end of the other PVC and stick it into the other end of the ball valve

8- this must be airtight with coldweld

9-make final adjustments

10-let dry and use spraypaint to paint it(I suggest that you put an orange tip)

11-You're done

Firing:Put in bbs, or your own grenade/missle. put the end of a bike pump into the bike pump valve in the End Cup. close ball valve. pump up with air, and when you open the valve it will fire a shower of bbs or a grenade/missle

Answer 2

It is potentially dangerous to make an airsoft flashbang that uses high explosives, however, a good starter would be fireworks, especially the small cylindrical ones that you need to light up with a lighter. Throwing them is easy, and although they do not 'stun' your opponents, they certainly distract them or even blind them! Just try it! They are cheap!

Answer 3

I thought about it, and I have a few diagrams for the piping, but I have decided that it'd take special equipment and experience to make one that did not blow up when you pressurized it, but could be reloaded quickly enough for combat use.