2external
2 timer
1 serial
1 hard rset
The difference between performance of 89c51 and 89s51 is that the 89c51 has a standard 51 core. The 89c51 program cannot be directly ported to 51 compared to the 89s51.
C stands for CMOS !!!!!!
89c51 is an microcontroller of 8051 series it is an 8-bit device packed in 40-pin package.
It means CHMOS
There are three types of interrupts.... 1. internal Interrupts 2. External Interrupts 3. Software Interrupts... read more
it has 256 interrupts ..
An interrupt is an event that alters the sequence in which the processor execute instructions. It is generated by hardware of computer system. Classes of interrupt:- IBM processor has six types of interrupts. * svc interrupt(supervisor call) *input/output interrupts *external interrupts *Restart interrupts *Program check interrupt *Machine check interrupts
In a typical interrupt priority scheme, the lowest priority interrupts are often referred to as "low-priority" or "background" interrupts, such as timer interrupts or non-critical peripheral interrupts. These interrupts are usually masked or delayed in favor of higher-priority interrupts that require immediate attention. Consequently, when a high-priority interrupt occurs, the low-priority interrupts may be temporarily ignored until the system has handled more urgent tasks.
1.The excluding interrupts are INT0 & INT1 2.The Timer0 and Timer1 are interrupts are generated by TF0 and TF1
In order to dump any program code onto a micro controller for a 89c51, you would first have to find access to the main controller board of the item, and plug the program code directly into that.
The 89C51 is also known as the AT89C51, which refers to a specific microcontroller from Atmel (now part of Microchip Technology). It is an 8-bit microcontroller based on the Intel 8051 architecture and is commonly used in embedded systems for various applications.
Maskable interrupts trigger events are not always important and so the programmer can decide that the event should not cause a program to jump. Nonmaskable interrupts can not be ignored by the programmer and therefore they have absolute priority.