0
What else can I help you with?
What causes a larger collision domain?
a collision domain is a group of devices where traffic from any one of them could collide with traffic from any other member of the same group. some devices help to shrink collision domains, like switches, while other devices can extend the size of a collision domain (like a hub).
Which device could be installed to reduce the size of the broadcast domain?
router
How does using a hub or a repeater affect the size of the collision domain?
A layer 1 device will extend a collision domain
What devices can you use to limit the size of a collision domain?
A switch or router will limit the number of clients in a collision domain, thus limiting what can be in the collision domain.
Network technician has been monitoring traffic with Wireshark and notices an excessive number of broadcasts Which device could be installed to reduce the size of the broadcast domain?
route r
What is a result of connecting two or more switches together?
Connecting two or more switches together creates a network switch stack, which allows for increased network capacity, redundancy, and manageability. This setup enables devices connected to different switches within the stack to communicate with each other seamlessly and efficiently.
What size are scaffold sole-plates?
They must extend 600mm past the standard so it depends on the size of your scaffold. They must extend 600mm past the standard so it depends on the size of your scaffold.
What Domain Kingdom have the smallest genome size?
eukaryotes, bacteria
What are pager-size data collection devices that cost roughly 300?
Skimmers are pager size data collection devices that cost about $300.
Which networking device increases the size of both collision domains and broadcast domains?
A Router
What is the standard m3 bolt size used for securing components in electronic devices?
The standard M3 bolt size is commonly used for securing components in electronic devices.
What is the standard m4 screw size used for securing components in electronic devices?
The standard M4 screw size is commonly used to secure components in electronic devices.
