answersLogoWhite

0

What else can I help you with?

Related Questions

Which mode does a router enter when no configuration file is located in NVRAM?

Global configuration


What shortcut command can be used to enter the privileged exec mode?

ena


What is the shortcut of ms-dos?

Go to Start -> Run and enter either "cmd" or "command"..


What short cut key of shortcut keys are used to execute the command Save As?

enter


What is the shortcut key for rename option?

The shortcut key for the rename option in most Windows applications is F2. In macOS, you can use the shortcut Command + Return (or Command + Enter) to rename files or folders. These shortcuts allow you to quickly initiate the renaming process without using the mouse.


What command is used to enter the router terminal configuration mode?

#configure terminal


Can you open a shortcut file?

Assuming you are talking about Microsoft windows it is possible to right click on the shortcut and select properties, this will show you what the shortcut points at, and the directory it expects to be running in. If you are talking about shortcuts on a unix box, enter the 'ls -l' command and the shortcut will be expanded so you can see the target


How do you enter the IOS5 codes?

To enter IOS 5 codes on a Cisco device, you typically access the device's command-line interface (CLI) through a console connection or SSH. Once logged in, you can use the "configure terminal" command to enter global configuration mode. From there, you can input the necessary IOS commands to configure the device as required. Ensure you have the proper privileges to make changes.


What is the command to put a banner on putty for routers?

To set a banner on a router using PuTTY, you can enter the global configuration mode by typing configure terminal. Then, use the command banner motd #Your message here#, replacing "Your message here" with the desired text. The # symbols are delimiters that define the beginning and end of the message. Finally, exit configuration mode by typing end or exit.


Which command correctly starts routing process in cisco router?

To start the routing process on a Cisco router, you typically enter the command router [routing_protocol] in global configuration mode, where [routing_protocol] could be protocols like rip, ospf, or eigrp. For example, to start the OSPF routing process, you would use the command router ospf [process_id], where [process_id] is a unique identifier for the OSPF process. This command enables the routing protocol and allows for configuration of related settings.


How do you view the basic IP configuration settings?

open Command prompt and type 'ipconfig/all' with out quotes and press Enter


What is the command used to get into global configuration mode on a cisco router?

On user exec mode type enable. When inside the privilege mode type configure terminal. You will then be sitting into global config after this. Please see below example: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#