answersLogoWhite

0

What else can I help you with?

Related Questions

Immediately after a router completes its boot sequence the network administrator wants to check the routers configuration From privileged EXEC mode what commands can the administ?

AB


Which router configuration mode would an administrator use to configure the router for SSH or Telnet login?

line


Password that works for every router?

There is no such thing. Every router has its own password, set by the network administrator. Or some routers may not have one.There is no such thing. Every router has its own password, set by the network administrator. Or some routers may not have one.There is no such thing. Every router has its own password, set by the network administrator. Or some routers may not have one.There is no such thing. Every router has its own password, set by the network administrator. Or some routers may not have one.


Which router configuration mode would an administrator use to configure the router for SSH or Telnet login access?

line


A network administrator enters the service password-encryption command into the configuration mode of a router What does this command accomplish?

This command enables a strong encryption algorithm for the enable secret password command.


Who gives the ip address to each computer?

Most usually the Dynamic Host Configuration Protocol that is set on a router, but sometimes the network administrator manually gives the ip addresses to each host.


What can a network administrator do to recover from a lost router password?

boot the router to ROM monitor mode and configure the router to ignore the startup configuration when it initializes Sorce: CCNA Final Exam Module 4 Cisco789


Which router configuration mode will require user authentification if an administrator issues the enable secret command?

It is the privilege mode.


How do you configure RIP routing protocol on a Cisco router?

Here is a basic overview of the configuration of RIP on a Cisco router:Router(config)#router ripRouter(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0The 192.168.x.0 address can be changed to whatever address you would like to be broadcast over RIP. There are also other settings that can be configured.If you use RIPv2 you can also have the following configuration:Router(config)#router ripRouter(config-router)#version 2Router(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0Router(config-router)#exitRouter(config)#exitRouter#%SYS-5-CONFIG_I: Configured from console by consoleRouter#copy running-config startup-configDestination filename [startup-config]?Building configuration...[OK]Router#


Which router configuration mode will require user authentication if an administrator issues the enable secret command?

privileged executive mode


How I can enable access to router configuration from external network?

I mean access from Internet the router type is TP-link (TD-W8151N)?


A network administrator has just entered new configurations into Router1 Which command should be executed to save configuration changes to NVRAM?

Discuss how a network engineer enters commands and changes to a router and ensures that the correct configurations are saved. Also discuss the importance of setting hostnames and passwords