0
What else can I help you with?
Where should a service valve be installed to an instantaneous electric water heater?
The 100%correct answer is as close as possible , because you don’t want to run around the building to close the tab .
What direction should the vapor barrier of insulation be installed?
towards the inside of the building
How high should a stair railing be installed for safety and compliance with building codes?
A stair railing should be installed at a height of 34-38 inches above the nosing of the stair treads for safety and compliance with building codes.
Which Produces guidelines for how network cable should be installed in commercial building?
Eia/tia
I need Gas Shutoff valve installed in a house located in city of Los Angeles?
Considering it is a gas valve you should call a plumbing and maintenance service around your area to get their rates.
How does one determine which Windows Vista service pack is installed?
Finding out which Windows Vista service pack is installed is fairly simple. Go to Start, Control Panel, System Maintenance and then the System link. It should show which pack is installed.
Where on a 1988 Buick Eletra would be a fuel pump installed?
It should be located in the fuel tank!!
Where can you purchase reliable auto windscreens?
Reliable auto windscreens should be purchased or at least inquired upon at your most reliable auto service center. Then they should be installed by a realiable service center.
How high above a metal roof should the electrical service be located?
it should be 5 feet
How should metal building electrical wiring be installed to ensure safety and compliance with regulations?
Metal building electrical wiring should be installed by a licensed electrician following the National Electrical Code (NEC) regulations. Wiring should be properly grounded, insulated, and protected from physical damage. Junction boxes should be used for connections, and all wiring should be labeled and organized. Regular inspections and maintenance should be conducted to ensure safety and compliance.
Is the exterior electric service entrance conduicts should be secured to the side of the home every?
in a overhead service,check code rule 6-112 sub 4 and appendix b rule 6-112 4 d (three support clamps are used, the upper one being located at the roof line and the other two being installed on the wall of the building)
Should you say a building is located at the corner or on the corner of an intersection?
Either option is acceptable.
