When installed properly and correctly, a copper line from heating system can be used to heat concrete slab.
Of course as you as you protect it JUST like radient heating is considered water lines in a concrete slab
If you're talking about the copper refrigerant line then the answer is no.
No If the hole is smaller then the diameter of the supply line
Epoxy coating is a possibility for repairing lines that are run through concrete. It is a god proven technology, and is fairly costly, but it lasts a long time, and does not involve removing the concrete slab.
Looking through the top by the fan . Look at your compressor if its a heat pumpbyou will have a accumalator which looks like an long can which your copper line runs to and you will also have a reversing valve which is attached in your line sets it will have three copper lines running to it and an electrical line to it also. A straight cool unit you will see nothing but a compressor. Also if your thermostate has a emergency heat most likely its a heat pump.
Using a copper refrigerator water line has benefits such as durability, resistance to corrosion, and flexibility. Copper is also less likely to leak or break compared to other materials, making it a reliable choice for connecting your refrigerator to the water supply.
Plates for printing handbills and copper was used in pots and pan bottoms. It still is today in the Revere pot and pan line of products. Copper is a good conductor of heat.
To repair a copper water line, you can start by turning off the water supply, cutting out the damaged section of the pipe using a pipe cutter, cleaning the ends of the pipe, and then soldering a new piece of copper pipe in place using a propane torch and solder. Finally, turn the water supply back on and check for any leaks.
To effectively repair a copper water line, you can start by turning off the water supply, cleaning the damaged area, cutting out the damaged section, and then soldering a new piece of copper pipe in place. Make sure to follow proper safety precautions and use the right tools for the job.
The best way to connect a 1/4 inch copper tubing to a water supply line is by using a compression fitting. This fitting allows for a secure and leak-proof connection between the tubing and the water supply line.
Nothing. It is water and it's supposed to do that.
Hot water line. If you did hook it up to your cold water line make sure your dishwasher is set to heat the water (some models have a selectable setting for this.)