Well, unless it's a temporary emergency repair, it's a bad idea. The P trap, used only in drain lines, is designed to allow water to pass at will while preventing sewer gas from coming back into the building through the drain. The P trap stays full of water, and so the sewer gas goes up through the vent stack to the atmosphere. The gate valve, used almost exclusively in supply lines, is designed to shut off liquid under pressure. I suggest you either call a plumber or visit a home store (Lowe's or Home Depot) and tell their guy what the problem is. They're usually very knowledgeable.
A bakugan trap is designed with differant shapes. A bakugan trap can only be played after the gate card has been opened,place the bakugan on the gate card *NOTE* the trap must be the same attribute as your bakugan(s) on the gate card. You may change the bakugan attribute to one of the attribute symbols on the trap.
=== ===
Not 100% sure about the '87, but there is no PCV valve on the 1986 Volvo 240 2.3L. Flame trap and Oil trap, but no PCV.
Are you sure you don't mean 'foot valve' - this is the valve at the bottom of a well suction pipe when you use a jetpump. I've never heard of 'foot trap'.
Any valve used to fill a vessel or tank or replenish a trap seal
you need to replace your oil trap . same as PVC valve cost about $40. for part to have it done close to$500.
By cutting it out and installing either a P trap or a running trap as an S trap is notorious for losing its seal
yes
It is not required to roll a Bakugan trap during game play. When you want to use it, simply place it on the gate card.
To replace a sink trap, first, turn off the water supply. Then, use a wrench to loosen the nuts connecting the trap to the pipes. Remove the old trap and replace it with a new one, making sure to tighten the nuts securely. Finally, turn the water supply back on and check for any leaks.
The TRAP instruction in the 8085 is NONMASKABLE, which means it cannot be masked, i.e. it cannot be disabled. The only way to mask or disable TRAP is with external hardware, such as an I/O pin and an AND gate.
To replace the oil trap on your Volvo, please consult your owners manual. There should be a guide in there to help you with this repair.