Yes....... But........
750mAh and 800mAh are the capacity of the battery. More capacity means more power.
The handset always assumes that the proper batteries are inserted.
If it was designed for 800mAh then the handset puts a charge of 800 into the batteries. If a 750mAh is inserted instead, it will overcharge the batteries. Overcharging is not good for batteries. Each overcharge will lessen the life of the battery. The batteries may heat up too much which could be dangerous.
In the vice versa case it might happen that the 800mAh batteries are always charged only upto 750mAh, giving you the same performance and not better.
So it completely depends on the way the handsets are designed.
A cordless telephone has a handset that is powered by a rechargeable battery and transmits with an antenna rather than a chord. This allows the user to carry the telephone with them to make and receive calls anywhere in their home.
Over time, the rechargeable battery of a cordless handset may lose its ability to hold a charge. To restore it back to original working order, use the handset but do not charge it until the phone signifies that it has a low battery. Once you receive the low battery alert, give the handset time to charge completely, according to the instructions on the handset manual. Repeat this process as needed to achieve full battery potential.
A telephone handset replacement can cost just a few dollars to over twenty dollars all depending on the type of phone and the type of handset being replaced.
The Cradle
carbon
Yes by not recharging the handset until it drains the battery.
The best handset for a VOIP telephone system is the X-50 VOIP small business phone system bundle. It comes with three telephones for use at home or business.
Another name for the telephone handset symbol #.
The word 'handset' refers to the phone itself. The word 'door' refers to the battery compartment cover.
A handset cord is a coiled or straight cable that connects a telephone handset to the base unit of a phone. It transmits audio signals between the handset and the phone, enabling communication. Handset cords are commonly found in traditional landline phones and can vary in length and design. They are essential for providing mobility and convenience while using the phone.
It is terminology used in the telephone industry in regards to when a telephone circuit is activated when the handset has been lifted from the cradle or off hook. Off hook comes from when telephones had separate receivers that you put to your ear to listen. It was hung on a hook device on the side of the telephone. The mouth piece was fixed stationary on the front face of the telephone and the whole telephone was mounted on the wall.
The basic parts of telephone set would include keypads/dial,handset, hook switch, circuit board and phone kit.