Chances are if you put a Pipe Wrench on the Pipe and turn it, you will damage the fitting that the Pipe screws into below ground. You should dig it up and use two Pipe Wrenches.
Unscrew the rod and change the seal at bottom end .
My skimmer is cracked on the side were the strainer basket fits. I used first PVC Primer & then PVC Cement. Its not leaking. These 2 small cans come packaged togaether. I got it at Home Depot.
To replace a tub stopper, you can unscrew the old stopper and remove it from the drain. Then, insert the new stopper into the drain and screw it in place. Make sure it fits securely to prevent water from leaking.
unscrew it from the transmission and unscrew it from the inst.panel
You unscrew the bolts.
open the bonet and unscrew the cover off then unscrew the bulb and replace and then put it all back together
There is bolts unscrew them and the replace again
You simply unscrew the antenna rod and replace it. Very easy.
unscrew
Unscrew and screw in new one.
unscrew them
To fix a leaking hose bib on your outdoor faucet, you can start by turning off the water supply to the faucet. Next, unscrew the handle and stem of the hose bib to access the washer. Replace the washer with a new one and reassemble the hose bib. Turn the water supply back on to check if the leak is fixed. If the leak persists, you may need to replace the entire hose bib.