With a deep floor flange Or a wax seal with a horn and extra long Brass floor flange bolts
You can install the vanity first. Then, install the tile up to the vanity and around the pipe for the toilet. Then, install the toilet. That way, you do not have to replace the tile should you ever have to replace the toilet.
If you are installing a floating laminate floor, you can easily put it right over the tile.
To replace floor tile, you will need to remove the old tile, prepare the surface, apply adhesive, lay the new tile, and grout the joints. Make sure to measure and cut the tiles accurately and allow time for the adhesive and grout to dry before using the floor.
To replace a cracked floor tile, you will need to carefully remove the damaged tile using a chisel and hammer. Clean the area thoroughly, apply adhesive to the back of the new tile, and press it into place. Allow the adhesive to dry completely before grouting the tile to finish the repair.
twice the material
Inside pipe cutter
To install a toilet flange on top of tile, first ensure the tile is clean and level. Use a wax ring to create a seal between the flange and the toilet drain. Place the flange over the drain and secure it to the floor with screws. Make sure it is level and flush with the tile surface. Finally, attach the toilet to the flange using bolts and nuts.
To properly tile around a toilet for a seamless and professional finish, follow these steps: Remove the toilet and clean the area around the base. Measure and cut the tiles to fit around the toilet flange. Apply thin-set mortar to the floor and place the tiles in position. Use tile spacers to maintain even spacing between tiles. Allow the mortar to dry completely before grouting the tiles. Apply grout to the tile joints and wipe off excess grout with a damp sponge. Replace the toilet and seal the base with silicone caulk for a finished look.
To replace a floor tile, first remove the grout around the tile using a grout saw. Then, gently pry up the tile using a chisel and hammer. Clean the area and apply adhesive to the back of the new tile before placing it in the empty spot. Press down firmly and allow it to dry before reapplying grout.
People generally charge extra when more work is involved. This is a good case - is it easier to remove and replace the toilet and lay the tiles intact than it is to leave the toilet in place and try to cut the tiles to fit around it? Having recently tiled by own bathroom floor, it was easier to remove the toilet and lay the 'whole' tiles and then to replace the toilet when the cement and grout had dried. (Then I ran some sealant around the join to prevent dirt catching, and to make cleaning the floor eaiser.)
To cut tile around a toilet, measure and mark the tile to fit around the toilet base. Use a tile cutter or a wet saw to make the necessary cuts. Place the cut tile around the toilet, ensuring a proper fit. Apply tile adhesive and grout to secure the tile in place.
Remove the toilet from the floor, locate the broken tip, and replace the toilet. Don't forget the new wax ring.