You use an acetylene torch and special brazing rods.
Equipment to braze metal is commonly available in hardware stores and is sold in kits. Typically, it consists of a torch and several types of rods to braze metal. that is not what im looking for yea that is my question
In order to braze the metal has to melt and the melting point of brass is 900-940*C depending on it's content.
Pot metal-no. Better to use jb weld or something.
Clean the base metal use a high temperature flux using a torch capable of getting the base metal almost cherry red and if you braze the joint properly your tensile strength should exceed 87,000
If its made from tin then neither is appropriate. It should be riveted, or joined with self-tapping sheet metal screws.
Yes, its a requirement of all manufacturers, that i know of, to braze 410a connections with a brazing alloy containing a minimum of 15%
YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints
you solder or braze it
zebra
Braze
In short, no you can't braze tin.Assuming that you are using a fairly standard set-up with an oxyacetylene torch you will burn straight through most grades of tin.
M. A Perkins has written: 'Electron-beam braze welding of beryllium' -- subject(s): Braze welding, Electron beam welding, Beryllium