answersLogoWhite

0

What kind of pipe, what feeds the pipe, and where is it located? If it is a floor drain, put some vegetable oil down the p-trap to seal the trap and stop the sewer gases from coming back.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you fix crack in clay sewer pipe under concrete?

Plumbers black pipe sealant by Hercules chemical corporation.


Are you able to fix broken glass?

only if crack under 6 inches


What do you do to the spaceship broken in the mud on popropica?

You have to fix the broken pipe on the spaceship by dragging the fuel rod onto it.


What is a crack pipe?

A pipe which believe or not crack is smoked out of!


How can I fix a broken PVC pipe?

To fix a broken PVC pipe, you can cut out the damaged section using a hacksaw, clean the ends of the pipe, and then use PVC primer and cement to attach a new piece of PVC pipe or a coupling to the existing pipe. Make sure to follow the manufacturer's instructions for the primer and cement for a secure and leak-free repair.


If pressure is applied to the top of a pipe where would the pipe crack?

Granted that the force was enough to crack the pipe, it would crack in the middle.


What causes white puffing smoke from a diesel engine?

The cause of white puffing smoke in a diesel is the crack pipe ventilator seal. Fix that it keeps the crack inside.


How can I fix a cracked pipe in my plumbing system?

To fix a cracked pipe in your plumbing system, you can start by turning off the water supply to the affected area. Next, clean and dry the cracked area. You can then use a pipe repair clamp or epoxy putty to seal the crack. If the crack is severe, you may need to replace the damaged section of the pipe. It is recommended to consult a professional plumber for complex repairs.


How can I fix a broken sprinkler pipe?

To fix a broken sprinkler pipe, you will need to first locate the damaged section of the pipe. Once you have identified the break, you can cut out the damaged portion and replace it with a new section of pipe using PVC pipe and fittings. Make sure to properly secure the new section in place and test the repair by turning on the sprinkler system to check for leaks.


How can I fix a broken water pipe outside?

To fix a broken water pipe outside, you will need to first locate the source of the leak. Once you have identified the broken section, you can shut off the water supply to that area and then repair or replace the damaged pipe. This may involve cutting out the broken section and installing a new piece of pipe, or using a repair clamp or epoxy to seal the leak. It is important to follow proper safety precautions and consider hiring a professional plumber if needed.


How can I fix a broken pipe?

To fix a broken pipe, first turn off the water supply to prevent further damage. Next, cut out the damaged section of the pipe using a pipe cutter or hacksaw. Clean the edges of the cut pipe and the replacement section. Apply pipe joint compound or plumber's tape to the fittings and connect the new section to the existing pipe. Tighten the fittings securely and turn the water supply back on to check for leaks.


How can I fix a broken PVC water pipe outside?

To fix a broken PVC water pipe outside, you can follow these steps: Turn off the water supply to the pipe. Cut out the damaged section of the pipe using a PVC pipe cutter. Clean and dry the ends of the remaining pipe. Apply PVC primer and cement to the ends of the pipe and the replacement section. Connect the replacement section to the existing pipe and hold in place for a few seconds. Allow the cement to dry completely before turning the water supply back on.