To open an iPhone 3G case that is stuck, start by using a plastic opening tool or a thin, flat object to gently pry apart the seams of the case. Begin at a corner or edge, applying gentle pressure to avoid damaging the device. If it remains stuck, you can try using a hairdryer to apply slight heat, which may help loosen any adhesive. Be cautious not to overheat the phone or apply too much force while prying it open.
no the iphone is much thicker
Check out Cellairis. They have plenty of iPhone 3g cases.
The only way is to buy a white coloured case.
it just wont work
Yes, but not perfectly snug.
it just wont work
Original Answer by Chohw0916 Edited by Arianna Lovendino Trust me. I have tried this. The case does fit the iPhone 2G. Though, there is one problem. The case will be very tight because iPhone 2G is a bit thicker than iPhone 3G.
you can't
No, you have to buy a waterproof case. ~
be careful
There is a small chance you have no enabled 3G. To do this follow these steps. Go to Settings > General > Network and Enable 3G should be set to on. Also your area may not have 3G capabilities. In this case there is no 3G signal for 3G to work. To check 3G coverage contact your provider. Also if your iPhone is a 1st Generation and not the iPhone 3G you do not have 3G capabilities.
No the case is different, buttons are different, and you have camera lenses on both front and back.