0
The well must be pulled. A couple methods to do this would be to make an oil derrick looking device out of 2x4's and lifting it with a come along, or do what I did and use a engine hoist positioned over the well. Either way, chances are it will be tough to pull because the leathers/seals at the bottom of the well catch on any rust that is inside the casing pipe (your actually lifting a smaller diameter pipe that sits inside a larger diameter casing pipe).
Once you finally get the well up, replacing the foot valve is as easy as unscrewing the old one and screwing on the new one. Even if your old leathers come out intact I highly recommend replacing them. Also make sure you inspect the other components before you drop anything back down into the well casing (you don't want to be doing this again..... do you?)
What else can I help you with?
Can you put a check valve in line to a water pump if the foot valve is leaking?
It will only work properly if you put it very close to the foot valve. In which case you may as well replace the foot valve - it's not difficult to do. If you put it at or near the pump, the pump will just suck air.
How do you change foot valve in shallow well?
To change a foot valve in a shallow well, first turn off the pump and disconnect the power supply. Remove the well casing cover and carefully pull up the pump and the existing foot valve using a well pipe extractor or a suitable tool. Replace the old foot valve with a new one, ensuring it is securely attached. Reinstall the pump, reconnect the power, and test the system for proper operation.
What is a foot trap?
Are you sure you don't mean 'foot valve' - this is the valve at the bottom of a well suction pipe when you use a jetpump. I've never heard of 'foot trap'.
How far from the bottom of the well to the foot valve?
5 feet.
How do you test foot valve in shallow well?
To test a foot valve in a shallow well, first ensure the pump is turned off. Remove the foot valve from the well and inspect it for any debris or damage. Submerge it in a bucket of water and manually operate the valve to see if it holds water and creates suction. If it fails to hold water, it may need cleaning or replacement.
How do you install a shallow well jet pump?
A shallow well jet pump sits on the ground next to the well. To install it, connect tubing to the intake side of the pump and put a foot valve on the end of the tubing to control the water. Lower the foot valve and tubing into the well. Remove the drain plug on the pump and pour water in it to prime it. Replace the drain plug, connect the pump to power and turn it on.
What is a foot valve?
A foot valve is something that you eat with your foot
Where can directions for replacing a foot valve be found?
Unscrew the old one and replace it with a new one. You'll have to reprime the line and the pump again to fill the void of air that is now in the pipe from changing the foot valve.
Will a well pump work without a foot valve?
A well pump can operate without a foot valve, but it will not maintain its prime effectively. The foot valve prevents water from draining back into the well when the pump is off, ensuring that the system remains primed and ready for the next use. Without it, the pump may struggle to draw water and could run dry, leading to potential damage. Therefore, while it may work temporarily, a foot valve is essential for optimal performance and longevity of the pump.
What size foot valve do you need?
The same size as the pipe it is hooked up to in the well.
What is the function of foot valve in the pump?
A foot valve, in relation to a water well, is a check valve at he bottom of a well to keep the water from running back into the well from the pump when the pump is not running. If the check valve does not hold the water the pump will lose it's prime and will not pump water.
What size foot valve?
The foot valve in a well should be the same size as the down pipe, usually 1 inch, but could be as small as 3/4 or as large as 1 1/2 . Foot valves are made in all those sizes.
