15 inches from outside edge of tub to center of toilet flange.
To replace a tub drain flange, you will need to remove the old flange by unscrewing it from the drain pipe. Then, clean the area around the drain hole and apply plumber's putty to the new flange before screwing it into place. Finally, test the new flange to ensure it is securely installed and not leaking.
The purpose of a tub flange is to create a watertight seal between the bathtub and the surrounding walls. It helps prevent water from leaking behind the tub and causing damage to the walls and floor. The tub flange is typically installed during the bathtub installation process and is an important component for ensuring a secure and waterproof fit.
standard height is 36 inches and if there is available wall space you should put it as close to the sink or shower/tub as possible.
The clog is below the point where the toilet and the tub join the drain.
According to the IPC code book it should be a minimum of 12 inches.
Putting toilet water into the tub with a cup.The real answer isWater seeks its own level and when a soil line (waste) is blocked water will find the lowest point to flow intoThus a toilet is above the tub and a basin is above the toilet.To prove allow water to flow in the basin and it should also flow into the tub
A bathroom would have a toilet-sink-tub and or shower. A half bath has a toilet maybe a sink but no tub or shower.
People go in a tub then the tub empties it into the air.
To ensure the waterproofing of a tub flange, you can use silicone caulk or waterproof sealant to seal the area where the tub meets the wall. Make sure to apply the sealant evenly and allow it to dry completely before using the tub. Regularly check for any signs of wear or damage and reapply the sealant as needed to maintain waterproofing.
The tub and toilet connect to the same drain at some point. The main drain was plugged but the connection between the toilet and tub was still open. Water seeks it's own level. When the water came up in the toilet, the tub was lower so some of it went there.
The part the flange screws on to may be a piece of all thread that can be changed for a longer one. If the stem of the faucet is not long enough now, you may have to get flatter flanges. If it is the stem not coming through the flange, I believe you can get extensions for the stem and a longer bolt to hold the handle on.
To install a new drain for a tub, follow these steps: Remove the old drain assembly. Clean the area around the drain hole. Apply plumber's putty to the new drain flange. Insert the new drain flange into the drain hole. Tighten the drain flange with a drain wrench. Connect the drain pipe to the new drain assembly. Test the new drain for leaks. Seal any gaps with silicone caulk if needed. These steps should help you successfully install a new drain for your tub.