answersLogoWhite

0

1.5 INCHES

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove a mild steel fitting from a pipe?

try 2 pipe wrenches or cut the pipe and remove remaining with a nipple extractor avail about any plumbing supply or home center


How do you connect a PVC pipe to a lead pipe?

You can put the steel pipe inside of the lead and melt the lead to seal it. That's takes experience and some talent. You can join them with a rubber sleeve that is the right size on each end and held in place with hose clamps. One cannot solder/ lead wipe lead to steel as one is ferrous and the other non ferrous metal You can lead wipe /solder lead to copper /bronze / brass To join to steel one had to lead wipe a brass nipple (called solder nipple) into the lead pipe and you have either male or female threads and then a union or left and right nipple and coupling to make a proper connection.'' By the way you cannot do a lead poured joint of steel into lead you can put the steel into a cast Iron hub and then use a caulked joint. Also the use of a no hub or a mechanical coupling will not be good for a water or gas tight against a lead pipe as lead is to soft.


What is use of pipe nipple?

Pipe nipple is use as connector to both pipe which have female end. It does not same as pipe reducer which nipple has same diameter throughout both end and threaded. Pipe reducer has different diameter for both end and it is use to join different pipe diameter.


What are the different types of nipple pipe fittings available for industrial applications?

The different types of nipple pipe fittings available for industrial applications include threaded nipples, close nipples, and hex nipples. These fittings are used to connect pipes and equipment in various industrial settings.


How much does a solid steel pipe 6 inches round by 24 inches long weight?

"Solid Steel" would not be a pipe- it would be a rod. Weight of pipe will vary depending on the thickness of the wall of the pipe.


What is a sch 10 pipe nipple?

A pipe nipple is a fitting, consisting of a short piece of pipe, usually to connect 2 pipe fittings. Sch 10 indicates the wall thickness of the pipe nipple. For example a sch 10 1" diameter nipple will have a wall thickness of 0.19". These standard wall thicknesses are specified in ASME B36.10M. A chart listing standard wall thicknesses can be found here: http://www.allsteelpipe.com/Pipe-Dimensions-Weights-Chart.pdf


What does an elbow do in plumbing?

Street Ell in places where a close nipple and Ell wont fit


Does Australia export steel pipe and tubes?

China is a large country to export steel pipe, if you want to buy steel pipe, you can import from China.


What is a pipe nipple and how is it used in plumbing systems?

A pipe nipple is a short piece of pipe with male threads on both ends. It is used in plumbing systems to connect two female threaded fittings together. The nipple acts as a bridge between the two fittings, allowing for a secure and leak-proof connection.


How long would it take to weld a 600mm steel pipe?

2 hours, at least


How do you get an internal pipe wrench to grab the nipple?

You insert the correct size wrench into the pipe and as you unscrew it, a cam grabs the inside and hopefully unscrews the nipple. It may break also. Most pipes are rusted too tight for an internal pipe wrench to loosen them. What you can do that takes a little time is insert a hacksaw blade in the nipple and cut a notch through the nipple. This relives the pressure on the nipple. Tap around the edge with a screwdriver or chisel and then try the wrench. For extremely rusty pipes, cut the nipple in 3 places and knock out the pieces.


Does Australia produce steel pipe and tubes?

Australia makes steel pipe and tubes