0
That is true. The EPAC Act of 2005 states that all old technology relating to electrical products IE: T-12 will no longer be Mfg. after 2010.
The power Grid on the East Coast in 2005 prompted the Govt. to reevaluate the way we use electricity.
The T-8 and T-5 use electronic ballasts replacing the "old technology" magnetic ballasts. In theory, the electronic ballasts use about 1/2 the electricity of magnetic ballasts.
What else can I help you with?
How do you replace a bulb for the Heating and Air Conditioning buttons on a 1999 Buick LeSabre?
Bulbs cannot be replaced. Entire control module must be replaced.
What will cause your running lights on a 98 gmc sierra to work but your dim headlights not work?
If by "dim headlights" you mean low-beams... the bulbs are bad and must be replaced.
How do you replace a tail light bulb on a Nissan Frontier truck?
Remove bedliner( if applicable). You must remove the taillight framing to get to bulbs. There are two screws located behind the taillight, that must be unscrewed to loosen the taillight frame from the truck body. Remove the two screws via the truckbed side and framing will loosen and bulbs can be replaced.
Do you have to replace catalytic converts that are bad or can you remove them?
They must be replaced.They must be replaced.
How many filaments exist in a light bulb?
Most incandescent bulbs have one filament. Some halogen bulbs working on 240 v have two filaments in series, which must be to simplify manufacture of bulbs being made for 120 v and 240 v in the same factory.
Can a catalytic converter be burned out or must it be replaced?
Legally a defective catalytic converter must be replaced.
Why bulbs connected inparallel?
all the bulbs must in parallel because all must get the same voltage.......in parallel voltage is constant.if they are connected in series they will not get same voltage
Gene has a string of lights on a series circuit. What will occur if one of the light bulbs on the circuit burns out?
If one of the light bulbs in Gene's series circuit burns out, the entire circuit will break, causing all the lights to go out. This happens because, in a series circuit, the electrical current must flow through each component in sequence. When one bulb fails, it creates an open circuit, preventing electricity from reaching the remaining bulbs. To restore the lights, the burned-out bulb must be replaced or repaired.
How do you get to the the dash bulbs to replace them on a 1989 Chevrolet Celebrity?
To change the dash light bulbs you must remove the instrument panel.
When you remove a bulb from a three bulb circuit and the other two bulbs go off then the bulbs must have been connected in?
help :(
How do you repair 2003 Ford Taurus rear catalytic converter?
You can't repair it. It must be replaced.You can't repair it. It must be replaced.
How do you replace the lights on the rear center panel on a 1994 Thunderbird?
If you are talking about the rear taillighs only the corner lights have bulbs pull back the inner trunk liner at the corner behind the light grab the grey or white plug and twist to remove the bulb the rear tailights on the trunk have no bulbs they are neon and if it is out the whole light assemble must be replaced
