0
What else can I help you with?
How far does separating plumbing pipes and electrical wiring?
Whether the pipes and wiring are chased or not. A minimum distance of 200mm is recommended. Making sure that the water pipes are always underneath the electrical wiring.
What is code for the distance from water pipes to electrical wires in Canada?
In Canada, the National Building Code (NBC) provides guidelines for the distance between water pipes and electrical wires to ensure safety. Generally, the minimum separation distance is recommended to be at least 30 cm (about 12 inches) between water pipes and electrical conduits. However, specific requirements can vary by province and should be verified with local building codes or regulations. Always consult the latest code and a qualified professional for precise compliance.
What is the minimum angle for water to flow?
for pipes up to 2" it is 1/4" fall per foot
What is the minimum distance for two tubewells?
The minimum distance between two tubewells typically depends on local regulations and geological conditions, but a common guideline is at least 50 to 100 feet apart. This distance helps prevent interference between the wells, reduces the risk of contamination, and ensures adequate water supply. It's essential to consult local water management authorities for specific requirements in your area.
What is psi in pipes?
It depends on what the pipe is for. Domestic water pipes run between 30 -70 psi in general.
What is pipes psi?
It depends on what the pipe is for. Domestic water pipes run between 30 -70 psi in general.
What should be the minimum distance between two tube wells?
There is no exact figure that can represent the distance between two tubewells. It depends upon the underground formation if two tubewells drilled at a distance of 100ft. and both sharing the same low water bearing aquifer then the discharge of one will effect the discharge of the other well. Distance should be as far as it could be, atleast more then 400ft. (minimum side) Farhan
Do hot water pipes freeze faster than cold water pipes?
Why is the second paragraph a contradiction of the first? If hot water pipes 'Absolutely' do not freeze faster than cold water pipes then why the comment about the cold water pipes having a larger diameter which causes them to freeze at a slower rate than the smaller hot water pipes? Also, the word then in the last line should be thanand there should be an a between usually and larger. And, piping should be changed to pipe.
Falls for foul drainage?
For 100mm pipes, the type normally used for residential drainage, the minimum acceptable falls are 1:40 for Foul Water and 1:100 for Surface Water. Larger diameter pipes may have gentler gradients in certain circumstances.
What is the name of the space between waste water pipes and floor drains?
Lag
Minimum distance required between two tubewell?
The minimum distance required between two tubewells typically ranges from 100 to 200 feet (30 to 60 meters), depending on local regulations and groundwater conditions. This spacing helps prevent contamination and ensures adequate water supply. It's important to consult local guidelines or water resource management authorities for specific requirements in your area. Additionally, factors such as aquifer characteristics and land use may influence the recommended distance.
What is minimum Sump pump distance to service panel?
The minimum distance between a sump pump and the service panel is typically recommended to be at least 5 feet. This distance helps prevent potential electrical hazards, such as water exposure to the electrical components. Always check local building codes and regulations, as they may have specific requirements that differ from general recommendations.
