No hub coupling
Pig Iron it is called in the trade
Extra heavy soil pipe (CI) requires NO Coating
By cutting in a cast iron Wye so the flow enters the sewer line (soil pipe) at a right angle
Toilet flanges OUTSIDE of the pipe including cast iron and brass to lead
The outside diameter (OD) of a cast iron pipe typically depends on its nominal size, which is specified in inches. For example, a standard 4-inch cast iron pipe has an outside diameter of approximately 4.5 inches. It's important to refer to specific standards, such as those from the Cast Iron Soil Pipe Institute (CISPI) or ANSI, for exact dimensions, as there can be slight variations.
Schedule 40 PVC pipe. Legal in all residential and up to 3 story commercial applications.
Hello I found this answer to the question... "How much oakum is required in 6 inch cast iron pipe before lead is poured into it?" From the Cast Iron Soil Pipe Association http://www.cispi.org/handbook/chapter4.pdf http://www.cispi.org/ Hope,this helps...
No-hub cast iron pipe is the same as hubless cast iron pipe. Both are terms used to identify a type of grey iron pipe that is manufactured for use in DWV and storm drainage applications. The terms "no-hub" or "hubless" refers to the pipes end. In contrast to "service weight" pipe, no - hub has no hub on the end and is joined using a no-hub coupling comprised of a 316 stainless steel shield with worm gears and a neoprene gasket. No hub pipe is manufactured to meet ASTM A 888 and CISPI (Cast Iron Soil Pipe Institute) 301 standards. To verify compliance you should use no - hub pipe and fittings bearing the NSF-upc (National Sanitation Foundation) mark.
Yes, it is possible. Unfortunatly, if you have a cast iron riser, you will have to chip out the concrete to get low enough to cut the riser to install a Clamp-all and a piece of PVC pipe. This might not be possible if you have a short riser. Then you would have to cut the cast iron behind the 90 degree turn. Either way, it's a pain in the butt. Call a plumber. It will be worth it.
Put a cutting blade on it and it shouldn't have water in it when you cut because of the possibility of shock.
Soil pipes are typically made from materials like cast iron, PVC, or vitrified clay. These materials are chosen for their durability, resistance to corrosion, and ability to withstand the pressures associated with wastewater drainage systems.
Very carefully drill a hole by each end of the split then gently grind a "V" shape in the split and then use a Cast Iron welding rod AFTER pre heating the base mental and allow to cool naturally as not to thermo-shock the metal