This sewer line is blocked further down. call a plumber to carry out an investigation to your main sewer line. it may need serious unblocking.
You can get a tool that is a steel corded plunging device for around $50 at Home Depot.
To use a power plunger effectively to unclog drains, follow these steps: Insert the plunger into the drain opening. Turn on the power and apply pressure to create a strong suction. Move the plunger up and down vigorously to dislodge the clog. Continue plunging until the water starts to drain freely. Turn off the power and remove the plunger from the drain. Remember to always follow the manufacturer's instructions for the specific power plunger you are using.
A toilet plunger works by creating a seal around the drain opening and using suction to dislodge and push clogs through the pipes. The plunging motion creates pressure that helps to break up and remove blockages in the toilet.
There may be a blockage further down the drain that the plunger cannot reach, or the blockage may be too large or solid to be dislodged by plunging. It is recommended to try using a plumbing snake or calling a professional plumber to resolve the issue.
To ensure your toilet flushes properly, regularly clean the inside of the bowl and the rim jets, check the water level in the tank, adjust the chain connecting the handle to the flapper, and consider using a plunger or auger to clear any clogs.
1. Flush handle is no longer connected to the flapper valve (chain broke)2. Drain is blocked- clear it with a tool called a closet auger- plunging with a plunger MAY work
As I push the plunger with the water, I feel resistance initially as I apply pressure to push the water out. As the water moves through the pipes, I might feel a slight release of pressure as the clog is cleared. If the clog is stubborn, I might feel additional resistance as I continue plunging until the blockage is resolved.
To unclog a drain using a plunger, follow these steps: Fill the sink or tub with enough water to cover the plunger. Place the plunger over the drain and push down firmly, then pull up quickly. Repeat this plunging motion several times until the clog is cleared. If the clog persists, you may need to use a drain snake or call a professional plumber.
To properly plunge a sink to unclog it, follow these steps: Fill the sink with enough water to cover the plunger. Place the plunger over the drain and make sure it forms a tight seal. Push and pull the plunger vigorously for about 30 seconds. Repeat the plunging process a few times until the clog is cleared. Run hot water down the drain to flush out any remaining debris.
I woke up with a terrible hangover and a plunger stuck to my forehead.Fetch the plunger, the sink is blocked again.
Plunger
Incredibly, no.