answersLogoWhite

0

You can access the tub drain by cutting through the ceiling below, or cutting through the side wall backing up to the tub.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How to find a leak in an inner tube?

One way would be to fill the tube with air, and then hold it under water and look for bubbles. Wherever the bubbles are originating from on the tube is the source of the leak.


Why do we heat the tube in a water bath and not directly over a flame?

IN Physics wards:Why do we heat test tube in a water bath and not directly over a flame?


Why do we heat the test tube in a water bath not directly over a flame?

IN Physics wards:Why do we heat test tube in a water bath and not directly over a flame?


What you must do to inspect the drink tube assembly?

perform a tube leak test perform a tube leak test perform a tube leak test perform a tube leak test perform a tube leak test perform a tube leak test perform a tube leak test


How many gallons of water in a half full bath tube?

depends on the size of the bath tub


Water dripping under dash board that is not antifreeze 2005 Chevy cobalt?

It may be condensation from your air conditioner condenser. The drain tube may be plugged causing water to back up and leak from under the dash. A windshield leak may also cause your problem.


The procedure indicates that the amount of time th test tube was kept in th boiling water bath should be minimized why was this necessary?

The procedure indicates that the amount of time the test tube was kept boiling in the water bath should be minimized. The water bath should never be allowed to boil dry.


What's causing a water leak at the engine fire wall rubber drain tube on a Chrysler PT Cruiser?

The drain tube is suppose to leak water when the A/C is running, This is the condenser drain line. Nothing is wrong.


Your 1994 Lincoln town car has a coolant leak and it seems like its coming from a little round cap under the engine next to the transmission what could it be?

There is a metal tube that runs under the intake manifold. It goes from the back of the water pump to the rear of the engine where it changes to a rubber heater hose. That metal tube is known to rust out and leak coolant. The intake manifold must be removed to gain access to the tube for replacement.


How fast should 4 inches of water in a bath tube drain?

depends if drain is clogged or not


Why shouldn't a test tube be placed in the water bath when left to cool?

please!! i need it urgently


Would heating the culture in a sealed small diameter tube that is totally immersed in a water bath produce more accurate results that the use of tubes that are partially submerged in a water bath?

Yes it would. This is because the whole tube would be in the water, making the measurements the same throughout.