Water weighs about 8.3 pounds per gallon or 1 gram per cc (ml) so the weight will be 415 lbs plus the weight of the container.
A gallon of water weighs about 8.34 pounds. So, a 50 gallon water heater full of water would weigh approximately 417 pounds.
about 100 lbs
It depends what's in the gallon. If the gallon is empty, it weighs zero. If it has air in it, it weighs a little bit. If it's full of water, it weighs about 8.4 pounds. If it's full of gold, it weighs about 160 pounds.
make sure the floor has no water damage, a water heater that size will weigh 350 lbs when full. it may fall thru if floor has any rot in it.
It would weigh just over 1600 pounds
No, it is not normal for a water heater pan to be full of water. If you notice this, it could indicate a leak or other issue with the water heater that needs to be addressed promptly.
The size of the water heater needed for a walk-in tub typically depends on the tub's capacity and the temperature of the incoming cold water. Most walk-in tubs require between 40 to 80 gallons of water for a full soak. To ensure you have enough hot water, it's advisable to have a water heater with at least a 50-gallon capacity for standard use, but larger tubs may require a 75-gallon or more unit. Additionally, consider the recovery rate of the heater to ensure you can refill it quickly if needed.
Yes. As long as you don't spill any of the water out of the drum when you get in, the total weight of the drum and water with you in it will be equal to the weight of the drum and the water plus the weight of you, separately. It doesn't matter if you float or sink. It will weigh about the same as it did before you climbed in. First, the answer above this one is wrong because you cant climb into a full 55 gallon drum without spilling water. As you enter the water, you will displace that volume with your body which weighs close enough to water to weigh near enough the same minus the amount of bouancy.
To determine if your hot water heater is full, you can check the water level gauge on the side of the tank. If the gauge indicates that the tank is full, then your hot water heater is full. You can also listen for a gurgling sound when the tank is filling up, which indicates that it is reaching capacity.
A 100-gallon fish tank weighs approximately 834 pounds when filled with water. The weight of the tank itself can vary depending on the material it is made of, but the water alone would weigh around 8.35 pounds per gallon.
A water heater typically takes about 1 to 2 hours to heat up a full tank of water.
Easy. Fill the 7gal pail to the full mark (7 Gallons) with water. Then pour, from the 7 gallon pail, water into each of the 3 gallon pail up to the full mark. The remaining water left in the 7 gallon is 1 gallon. Pour this gallon into the aquarium. Fill the 7 gallon pail with water, again to the full mark, and then add to the aquarium. 1 Gallon + 7 Gallons = 8 Gallons.