The VTP domain cannot be modified.
VTP transparent mode allows a switch to forward VTP advertisements but does not participate in the VTP domain. This mode is useful when you want to maintain VLAN information locally without affecting the rest of the VTP domain.
Three VTP parameters that must be identical on all switches to participate in the same VTP domain include domain name, domain password, and version number. VTP stands for VLAN Trunk Protocol. The answer can be found at http://www.ccna4u.org/2011/06/ccna-3-chapter-4-2011-v4-0-answers-100.html
Layer 2 multicast. vtp is stopped at the router.
Yes.
The switch has been reset. The VTP domain name has been changed.
TransparentTransparent is a bit iffy..? By default, a Catalyst switch is in the no-management-domain state until it receives an advertisement for a domain over a trunk link or until you configure a management domain. However, the default mode is Server mode.
Transparent mode
For VLAN Trunking Protocol (VTP) to function correctly, all switches in the VTP domain must be configured with the same VTP domain name. Additionally, at least one switch must be set to VTP server mode to create and propagate VLAN information, while other switches can be configured as clients or transparent modes. Proper trunking must also be established on the links connecting the switches to facilitate the transmission of VTP advertisements.
All VLANs that are configured on this switch will be sent to all other switches in the same VTP domain. Adding this switch to the network will cause no disruption in the VTP domain operations if the rest of the switches in the same domain have a higher configuration revision number.
unable to add VLANS can forward VLAN information to other swithces in the same VTP domain
Select the correct VTP mode and version. Configure the switch with the name of the new management domain. Verify that the switch has a lower configuration revision number than the other switches in the new domain.