answersLogoWhite

0

not being aware of the shape and construction of your home I can only generalize. Depending on how long this has been happening and how much moisture is leaking in you could have serious damage or at least some formation of mold. I would suggest finding the point of entry on the exterior wall and repairing and recaulking any damage first. Then wall covering will need to be opened and an inspection made to determine how to proceed. If major damage has occurred you would usually want a qualified professional to inspect and repair it. The door is open on how to remove minor mold damage from simple soap and water and bleach to a full-blown, and expensive mold removal professional. Check your local codes to see what restrictions apply to your situation. Good luck.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

When it is raining hard, water accumulate on the floor, I'd like to find out where the water is coming from without removing the wall inside the or the stucco outside the house. ?

You could hire a local handyman, most of them have clever ways of tracing such small leaks.


What happens when a cell wall runs out of water?

You die


WHAT NEEDS TO BE REPLACED WHEN Antifreeze leaking from wall pipe on Pontiac grand am?

WHAT NEEDS TO BE REPLACED WHEN ANTI FREEZE LEAKS FROM CAR WALL PIPE WHAT NEEDS TO BE REPLACED WHEN ANTI FREEZE LEAKS FROM CAR WALL PIPE WHAT NEEDS TO BE REPLACED WHEN ANTI FREEZE LEAKS FROM CAR WALL PIPE WHAT NEEDS TO BE REPLACED WHEN ANTI FREEZE LEAKS FROM CAR WALL PIPE


When water is diverted from tub faucet to shower faucet it leaks behind wall?

You have a leak between the diverter and showerhead or the arm for the showerhead is not sealed properly into the fitting in the wall


How can I safely install a refrigerator water line in a wall?

To safely install a refrigerator water line in a wall, follow these steps: Turn off the water supply to the area where you will be installing the line. Use a stud finder to locate the studs in the wall and plan the route for the water line. Drill a hole through the wall using a drill bit that is appropriate for the size of the water line. Insert the water line through the hole and secure it in place using appropriate brackets or clips. Connect the water line to the refrigerator and turn on the water supply to check for any leaks. Once you have confirmed that there are no leaks, secure the water line in place and patch up any holes in the wall.


Why does the back wall of your house get wet but the ceiling and wall are dry and now it's wet between bathroom and master bedroom not near the back wall?

If the "wet" is on or near a wall that has plumbing, you have a water leak inside the wall. The wall board is channeling the water to a point where it can excape - either to the exterior of the house (the "back wall") or to the interior of the house (between the bathroom and the master bedroom). In other words, gravity right?


Where is the pressure valve on your house?

It will be close to the inside wall where the water supply passes into the house from the line going towards the water meret.


How do you find a water leak?

Water leaks can be tricky. If water is visible on a wall then it could be necessary to cut into the wall to find a leak. Listening in a very quiet house may allow you to hear a spraying leak. If a leak is suspected because of a high water bill, look at the water meter. The small dial moves when water runs. Shut off cut offs under the sinks and toilets and the water should stop running. Turn them on one at a time and watch until the meter tons again. There is your leak.


Why does water leak at the stem wall?

Water can leak at the stem wall due to several reasons, including poor drainage, cracks in the foundation, or improper waterproofing. When water accumulates around the stem wall due to inadequate drainage, it can seep through any imperfections or gaps. Additionally, hydrostatic pressure from saturated soil can force water into the wall. Regular maintenance and proper drainage solutions are essential to prevent such leaks.


Why the wall of the house is important?

why the wall of the house is important


What are the steps involved in outdoor faucet installation?

The steps involved in outdoor faucet installation include selecting a suitable location, shutting off the water supply, drilling a hole in the wall, attaching the faucet to the wall, connecting the water supply lines, and testing for leaks.


What are the steps to properly install a washer drain in a wall?

Locate the ideal position for the washer drain in the wall. Cut a hole in the wall for the drain pipe. Install a P-trap to prevent sewer gases from entering the house. Connect the drain pipe to the P-trap and secure it in place. Test the drain for leaks and proper drainage. Seal around the drain pipe to prevent water damage. Patch up the wall around the drain for a finished look.