0
What else can I help you with?
Why would an American Standard toilet overflow after you flush?
Clogged drain or toilet. Also check the vent holes under the rim and clean the out.
Where is the vent hole located on the toilet?
Vent hole or holes are located under rim of toilet.Best way to see it is with small mirror.Take clothes hanger and make sure all holes especially the large ones are not clogged .They will become clogged from time to time.
How can I fix a slow toilet flush?
To fix a slow toilet flush, you can try adjusting the water level in the tank, checking for clogs in the toilet or pipes, cleaning the flush holes under the rim of the toilet bowl, or replacing the flapper or fill valve in the tank if they are worn out.
Why would the toilet not empty all water from the bowl when flushed?
It sounds like you need a new ballcock valve or either your fill tube has come off your flush valve. Just take tank lid off and check to see if water is going down the tube in middle of tank.
What kind of plumbing problem causes a wet floor when toilet is flushed and water is backed up in the shower next to it. The toilet bowl has not refilled but the toilet water reservoir is full.?
Sound like you have a clogged toilet and or a clog in your main drain under your toilet. Shut off water supply to toilet remove water from toilet tank. Puchase a wax ring for your toilet prior to disconnecting toilet from supply line and floor bolt on the right and left of your toilet. Remove toilet from floor if water is standing in pipe under where toilet was this is where your problem lies. If no water or clog present, turn toilet on side and lokk in hole at the bottomof toilet. Clear was is stuck in toilet clean off old wax ring install new one and put toilet back together.
What would cause a toilet to completely flush every other time and it always has to be flushed twice?
This could indicate a problem with the flushing mechanism. It's possible that the flapper valve is not sealing properly on every flush, leading to incomplete flushing. Additionally, there may be a partial clog in the toilet's drain pipe, requiring a second flush to fully clear the bowl. A plumber can inspect and repair the toilet to resolve these issues.
What could be wrong with a basement toilet if you have to use a plunger every time you flush it even with clean water even after you ran a snake from the top and bottom after removing the toilet?
Either the toilet is plugged or the sewer line under the toilet is plugged. At this point I would suggest calling in an expert (plumber) to determine the problem. You have not given enough information to say. Sounds like you do not have enough water pressure coming in to wash the waste away. Check out the holes under the lip of the toilet seat to see if they are blocked, causing you to get an inefficient flush. Our new toilet is much better at flushing with lesser amounts of water.
What happens to pee in an airplane?
Everything from the toilets goes into holding tanks under the toilet and get emptied by special trucks each time the aircraft lands.
How can I fix a slow flushing toilet?
To fix a slow flushing toilet, you can try cleaning the holes under the rim of the toilet bowl, adjusting the water level in the tank, checking the flapper for damage, and ensuring the chain connecting the handle to the flapper is properly adjusted. If these steps don't work, you may need to call a plumber to check for more serious issues.
How can I fix a weak toilet flush?
To fix a weak toilet flush, you can try adjusting the water level in the tank, checking and cleaning the flush holes under the rim of the bowl, or replacing the flapper or fill valve if they are worn out. If these steps do not improve the flush, you may need to consult a plumber for further assistance.
How do you unclog your toilet drain when you flush all the water comes out under the bottom of the toilet onto the floor?
pull the toilet. Make sure the trap is clear on the toilet, and then snake the toilet line.
How to effectively clean under the rim of the toilet?
To effectively clean under the rim of the toilet, use a toilet brush with bristles that can reach under the rim. Apply a toilet bowl cleaner or a mixture of vinegar and baking soda, let it sit for a few minutes, then scrub vigorously with the brush. Rinse thoroughly with water.
