answersLogoWhite

0

Bottom of the air tank.

Used to drain the water in the bottom off the tank

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you change the fuel filter on a 2001 gsx 600?

the fuel filter is located inside the tank and is attached to the petcock. remove the tank and then the petcock the filter will be located on top of the petcock disassemble clean and reassemble carefully replace gas tank and your ready to go...


How do you remove the petcock from the tank of Honda vtx 1300?

To remove the petcock from the tank of a Honda VTX 1300, first ensure the fuel valve is in the "OFF" position and disconnect the fuel line. Next, remove any screws or bolts securing the petcock to the tank; some models may require you to detach the mounting bracket as well. Carefully pull the petcock straight out, taking care not to damage the tank or any gaskets. Finally, clean the area before installing a new petcock or reassembling.


How do you remove petcock Yamaha kodiak?

To remove the petcock on a Yamaha Kodiak, first, ensure the fuel tank is empty and disconnect the battery for safety. Next, locate the petcock, typically found on the bottom of the fuel tank, and use a wrench to loosen and remove the mounting screws or bolts. Carefully detach the fuel lines from the petcock, ensuring no fuel spills, and then you can remove the petcock from the tank. Finally, clean the area and inspect for any debris or damage before installing a new petcock if needed.


On the air brake system of a semitruck with pull trailer does the air pressure maintain itself if the petcock on the wet tank is fully opened?

Yes, you still have your primary and secondary air tank.


How to remove Gas tank on 1980 suzuki gs850g?

first shut off petcock, then disconnect fuel line at petcock,remove the seat and the bolt at rear of tank. raise rear of tank and pull back on tank disengaging the forward mounts.


Where is the fuel gas shut off for 883?

there is a petcock on the tank


How do you drain a gas tank?

When emptying out a motorcycle gas tank you can put a funnel under the petcock leading into a gas can big enough to hold the gas you have in the tank. Open the petcock and let it drain. It may take a while but can be easier than siphoning or removing the tank.


Where is the fuel filter located on 2004 Honda Shadow Aero?

The fuel strainer is found inside of the fuel tank on top of the petcock. Loosen the 30mm petcock retaining nut. remove the petcock. The plastic screen tube must be pulled out of the tank. Clean or replace as necessary.


Where is the reserved tank on a kfx 400 ATV?

in any motor vehicle, the reserve is actually in the gas tank itself. the petcock has two levels in which it sucks gas. one higher the the other. the higher one is wjen the petcock is on on, and the smaller one is activated when you turn the petcock to reserve.


Where is the air filter located on a Magna V45 Honda Motorcycle?

It is under the gas tank, to reach it you must remove the 2 screws in the front of the gas tank. *Edit to original poster's answer; You also have to remove the seat, and take out the bolt at the back end of the fuel tank. Before lifting the tank off, turn the petcock off, and remove the fuel line from the base of the petcock. The air filter is right there. You can use canned air to blow it clean if it isn't too dirty. If it is really filthy, it is best to replace it outright. Hope this helps.


Where is the fuel filter on Yamaha Kodiak 400?

the fuel filter is inside the fuel tank. it is attached to the petcock,its a little screen. you have to remove the petcock to clean it properly. or you can blow air back through the gas line,this will free up the dirty screen a little. make sure you take the gas cap off the tank,or it could rupture the tank. always use extreme caution when working with fuel.


How do you replace petcock valve on a 2002 Honda rancher?

To replace the petcock valve on a 2002 Honda Rancher, first, make sure the fuel tank is empty and disconnect the fuel line from the valve. Remove any mounting screws or bolts securing the petcock to the tank and carefully take it out. Install the new petcock by reversing the removal process, ensuring all connections are secure and leak-free before refilling the tank with fuel. Always check for proper functionality after installation.