Mutual conductance, often denoted as ( g_m ), is a key parameter in field-effect transistors (FETs) that measures the change in the drain current in response to a change in gate voltage while keeping the drain-source voltage constant. It essentially reflects the transistor's sensitivity to gate voltage variations, indicating how effectively the gate controls the flow of current between the source and drain. A higher mutual conductance value indicates greater amplification capability and better performance of the FET in amplifying signals.
Specific conductance is the conductance of a specified length of a substance, typically 1 cm, while equivalence conductance is the conductance of all ions produced by one mole of an electrolyte in solution. Specific conductance is a property of the substance itself, whereas equivalence conductance is a property of the electrolyte in solution.
Specific conductance is directly proportional to the concentration of electrolyte, while equivalent conductance is inversely proportional to the concentration of electrolyte. This is because specific conductance is the conductivity of a solution normalized to a unit concentration, while equivalent conductance is the conductivity of a solution containing one equivalent of the electrolyte.
If conductance decreases, the current flowing through the circuit will also decrease. Conductance is the inverse of resistance, so decreasing conductance means increasing resistance, which impedes the flow of current.
No it will have high conductance
Hard to answer this one.The triode is a diode with a control electrode (the grid) added.The only useful answer is that a triode is a voltage-controlled doide.Try asking the question so that it can be answered more usefully.
Corrected conductance is calculated to account for the impact of temperature on the conductance of a substance. Conductance is temperature-dependent, so correcting for this allows for a more accurate comparison of values across different temperatures. It helps to standardize conductance measurements and make them more reliable for analysis.
a tetrode is used when you need a screen grid tube, but a suppressor grid tube can't be used.OK, but the question was "why use a tetrode instead of a triode?"So, the answer...1. A tetrode has a higher voltage/power gain than a triode.2. A tetrode has less anode-grid feedback capacitance than a triode, and can operate in common-cathode radio frequency circuits without the neutralisation (or other corrective circuitry) that is needed by a triode.
A triode works as a basic amplifier by the use of radio waves. The radio waves produce a heat that is amplified.
Can a triode tube PET 25W be damaged due to electric fluctuation
Conductance is ignored in short circuit studies because the inductance of the line is the dominant value. Conductance may not be ignored in stability studies.
A crystal triode is the old term for transistor. Crystal diodes were well established by the time transistors were invented, so using vacuum tube terminology, the logical name for a diode whose current could be controlled by a third element was "crystal triode".