0
What else can I help you with?
What is the bypass pipe from the heater core to the radiator called?
Heater coolant bypass pipe It would be the return hose for the heater.
What is that outbound pipe from the engine block to the heater core called?
A heater hose (rubber) or pipe (steel).
Which pipe goes to hot water heater?
Cold water pipe.
How do you remove the heater pipe from the engine block?
how to remove timing cover with heater pipe attached 92 olds 88 3.8l
How do you replace a heater return tube on a 2001 Dodge Intrepid se?
From the Dodge forums. Drain the coolant, disconnect the surge tank to heater pipe line, and the heater core to heater pipe line, remove the drivers side engine mount, and the starter, and unbolt the heater pipe from the engine-transmission bolt. Remove the clamp from the short hose at the thermostat housing, and pull the pipe out.
How do you replace the water heater inlet pipe on the intake manifold on a 3800 buick lesabre?
replace the water heater inlet pipe on the intake manifold on a 3800
How close can you install cpvc pipe to a gas water heater?
There should be no more than six inches between CPVC pipe and the exhaust flue on a water heater. If the CPVC pipe is installed too close it can be a safety issue.
What are the best practices for installing a tankless water heater vent pipe?
When installing a tankless water heater vent pipe, it is important to follow these best practices: ensure proper sizing and placement of the vent pipe, use high-quality materials that are compatible with the heater, and follow manufacturer guidelines for installation to ensure safety and efficiency.
What type of vent pipe be used to vent a gas water heater through a ceiling and roof?
B-vent pipe.
What is the recommended installation height for a vent pipe for a tankless water heater?
The recommended installation height for a vent pipe for a tankless water heater is typically between 12 to 18 inches above the unit.
What are the regulations and best practices for installing a water heater discharge pipe?
When installing a water heater discharge pipe, it is important to follow regulations that require the pipe to be made of an approved material, have a proper slope, and terminate in a safe location. Best practices include using a dedicated pipe for the discharge, ensuring it is properly supported, and avoiding any obstructions or bends in the pipe.
Services?
Plumbing And Drainage Emergency Plumbers Water Heater Maintenance Tankless Water Heater Installation Water Pipe Leak Repair Drain Pipe Installation Sewer Pipe Replacement Blocked Toilet Repair Toilet Tank Replacement Garbage Disposal Troubleshooting
