answersLogoWhite

0

If it is 3 in. Then take off 3 in. and so on for what ever size you are use

if it is 2 in. then 2 in.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Are pipings and pipe fittings the same?

No, fittings go over the pipe


How to measure pipe fittings accurately for proper installation?

To measure pipe fittings accurately for proper installation, use a measuring tape or caliper to determine the diameter and length of the fitting. Ensure the measurements match the specifications of the pipe and the connection points for a secure and leak-free installation.


What is the bevel degree onbutt weld fittings?

between 30 and 40 degrees preferably 37 like pipe


What is pipe take off?

A pipe take off is a method used in plumbing and construction to determine the length of pipe needed for a specific project. It involves measuring the distance between two points where the pipe will be installed and then calculating the necessary length, often taking into account factors such as angles, fittings, and potential bends in the pipe. This helps ensure that the correct amount of pipe is ordered and installed for the job.


How do you rectify leakage on pipe fittings threaded joints without removing the pipe fittings?

You cannot do that effectively without taking the fittings apart,


Can you use pressure fittings on three-quarter inch OD steel pipe for natural gas fittings for kitchen stove or do you always have to use threaded?

Not sure what you mean by pressure fittings. Threaded fittings for steel pipe are pressure fittings. Steel pipe with a 3/4" O.D. is known as 1/2" I.P.S. (Iron Pipe Size) pipe.


In pipe fitting sizes such as -4AN what does AN stand for?

AN stands for Army Navy. The AN fittings have a 37 degree conical end which is what makes the seal.


Where are places in Houston one can buy pipe fittings?

There are a few places in Houston where one can purchase pipe fittings. A good place to try is Pipe Fittings. Another good place to try is Home Depot.


What is the take off formula off 45 degree elbow pipe?

The take off formula of a 45 degree elbow pipe, will depend on what the pipe is on. Sometimes a 45 degree pipe will need a 90 degree right angle turn to come off.


Are pipe and pipe fittings can be different schedule?

No, they need to match.


What has the author Thomas S Walsh written?

Thomas S. Walsh has written: 'Plastic pipe and fittings' -- subject(s): Plastic Pipe, Pipe fittings, Standards


What does wpb stand for in pipe fittings?

Worught Pipe Bend