Normally $1,200 including the barrel waste (standing)
Of course
=== ===
By cutting it out and installing either a P trap or a running trap as an S trap is notorious for losing its seal
To remove a P-trap from a sink, first place a bucket underneath to catch any water. Loosen the slip nuts on both ends of the P-trap using a wrench or pliers. Carefully remove the P-trap and clean out any debris. Replace the P-trap and tighten the slip nuts securely.
Depending on the type of material the trap and waste piping are made of with determine how it is replaced
To effectively remove a P-trap from a sink or drain, follow these steps: Place a bucket underneath the P-trap to catch any water or debris. Use a wrench to loosen the slip nuts on both ends of the P-trap. Carefully remove the P-trap and clean out any debris or buildup. Inspect the P-trap for any damage and replace if necessary. Reattach the P-trap by tightening the slip nuts securely. Run water to check for any leaks and make sure the P-trap is properly installed.
A frost proof toilet the trap is located below the frost line
It can, but you better check codes, because some local codes do not want them or S traps.
No less then $760 If the job is performed properly
To replace a P-trap in a sink, first, turn off the water supply. Then, place a bucket under the trap to catch any water. Loosen the slip nuts on both ends of the trap and remove it. Install the new P-trap by connecting it to the drain pipe and the sink tailpiece. Tighten the slip nuts securely. Finally, turn the water supply back on and check for any leaks.
The unpleasant smell coming from your p-trap could be caused by a buildup of debris or bacteria. To get rid of it, you can try cleaning the p-trap with a mixture of baking soda and vinegar, or using a commercial drain cleaner. If the smell persists, you may need to replace the p-trap.
it keeps the floor drain p trap full of water so it does not dry up and let sewer gases up