answersLogoWhite

0

well most homes should have 60 to 80 psi. If you have a well and you only have a two story home then I would set the pump pressure to 60 psi, if you have city water and your pressure is above 80 , I would recommend installing a pressure reducer valve with shut offs on both sides so a person can service it in the future.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What to do if the water pressure in your house is too high?

There is usually a main water valve that comes into the house, locate this valve and turn it down. Installing a pressure reducing valve after water main valve will allow for adjustment of water pressure to proper setting.


What would make the water pressure in a house go above 80 psi?

Area water authority could have increased water main pressure, no or defective expansion tank in house main water line if house has a backflow preventer installed, or defective /not properly set pressure reducing valve.


What should you do if your main water pressure is to high?

Call the water board, if you can't turn the pressure down on the boiler.


How can I effectively reduce water pressure in my house using a water pressure reducer?

To effectively reduce water pressure in your house using a water pressure reducer, you can install the reducer on the main water line entering your home. Adjust the reducer to the desired pressure level to ensure a steady and safe flow of water throughout your plumbing system.


How can I fix high water pressure in my house?

To fix high water pressure in your house, you can install a pressure regulator on your main water line. This device will help control and reduce the water pressure to a safe level for your plumbing system. It is recommended to consult a professional plumber for proper installation and adjustment.


How deep should a main water line be from meter to house in Kentucky?

how deep should water line be from meter to house in Versailles Kentucky


Does the main water supply have to be turned off and the pipes drained before you can turn the screw on the pressure valve to increase the water pressure in house?

Yes, it is recommended to turn off the main water supply and drain the pipes before adjusting the pressure valve to increase water pressure in the house. This helps prevent damage to the plumbing system and ensures a safe working environment for adjustments.


Where is my water pressure regulator located in my home?

The water pressure regulator in your home is typically located near the main water supply line where it enters your house. It is usually found close to the water meter or the main shut-off valve.


Where to find water pressure valve?

On Ur main cold water line on house Looks like a brass cone


Should you shutoff the water main in an unoccupied house over the winter?

yes you should


What temp should running tap water be cold Side?

What ever the water suppy is comming into your house. -- If the main water comming into your house is 70 degrees then it should be the same after you run the water for a little bit inside your house. If you are not using water inside your house and it is 80 degrees inside. That is why you run the water to clear out your lines so it will be the same as main water.


How can you increase water pressure in your house?

To increase water pressure in your house, you can try the following methods: Check for any clogged pipes or fixtures and clean or replace them if necessary. Adjust the pressure regulator valve on your main water line. Install a water pressure booster pump. Consult a professional plumber for further assistance if needed.