0
What else can I help you with?
What should you do when a the tip of the toilet auger break off in the toilet?
Remove the toilet from the floor, locate the broken tip, and replace the toilet. Don't forget the new wax ring.
How to unclog an overflowing toilet?
To unclog an overflowing toilet, first turn off the water supply to the toilet. Use a plunger to try and dislodge the blockage by creating a seal around the drain and pushing and pulling the plunger vigorously. If the plunger doesn't work, you can try using a toilet auger to break up the clog. If these methods don't work, you may need to call a plumber for assistance.
How to unclog a toilet that is overflowing?
To unclog an overflowing toilet, first turn off the water supply to the toilet by turning the valve behind the toilet. Use a plunger to try and dislodge the blockage by creating a seal around the drain and pushing and pulling the plunger vigorously. If the plunger doesn't work, try using a toilet auger to break up the clog. If the toilet is still overflowing, it may be necessary to call a plumber for further assistance.
How do you effectively drain a toilet bowl?
To effectively drain a toilet bowl, start by turning off the water supply valve located behind the toilet. Next, use a plunger to create a seal over the drain hole and push and pull it vigorously to dislodge any clogs. If the plunger doesn't work, try using a toilet auger to break up and remove the blockage. Finally, once the water has drained, turn the water supply back on and flush the toilet to ensure it is draining properly.
Can an auger permanently scratch porcelain. Had toilet snaked today. Scratches in toilet after Rotor Rooter man leaves. Won't come out. Is he responsible 4 damage. Looks bad. Pls Advise?
I suspect he gave you the option of pulling the toilet or going through it with the auger. If he didn't, he should have. It's an additional charge, maybe $40. If he did and you decided not to pull it, you would probably be responsible for any damage. It may not be scratches in the porcelain but instead metal that has rubbed off of the auger. If it is below the water line, shut the water off and get the water out of the bowl to below the marks. Use some baking soda and a damp towel to polish out the marks. Scouring powder will probably take them out also but is more abrasive and may leave more scratches that may tend to collect stains.In doing plumbing for over 43 YEARS I yet to have a toilet scratched by using an auger properly.The augers have rubber sleeve to protect the metal from coming into contact with the china.The problem with many franchises is lack of FORMAL training and licensing of their employees (Journeyman's card)They should be held responsible for toilet replacement, that is why they should have liability insurance. When my augers have the slightest signs of wear (rubber sleeve tearing) I replace them as a good quality auger cost about $125 and a toilet stoppage to clear cost $125 - $175 (without removing the bowl) thus the very first time the auger is used it pays for itself so it does not make any sense to have use a defective one
What should you do when you flush the toilet and the water starts rising?
If the water starts rising after you flush the toilet, you should quickly turn off the water supply to the toilet by twisting the shut-off valve located behind the toilet. This will prevent the toilet from overflowing.
What should I do if I notice my toilet leaking from the bottom?
If you notice your toilet leaking from the bottom, you should immediately turn off the water supply to the toilet by shutting off the valve located behind the toilet. Then, you should contact a plumber to assess and repair the leak to prevent further damage.
How to drain a toilet to remove blockages effectively?
To drain a toilet to remove blockages effectively, follow these steps: Turn off the water supply to the toilet by locating the shut-off valve behind the toilet and turning it clockwise. Use a plunger to try and dislodge the blockage by creating a seal around the drain and pushing and pulling the plunger vigorously. If the plunger doesn't work, try using a toilet auger or a plumbing snake to break up and remove the blockage. If the blockage is still not cleared, consider using a chemical drain cleaner, following the manufacturer's instructions carefully. Once the blockage is cleared, turn the water supply back on and flush the toilet to ensure proper drainage.
What should I do if I notice water leaking from the base of my toilet?
If you notice water leaking from the base of your toilet, you should immediately turn off the water supply to the toilet by shutting off the valve located behind the toilet. Then, you should contact a plumber to inspect and repair the issue to prevent further damage.
What can you do if you turn the water off on the main floor underneath the toilet can you use the bathtub upstairs?
Unless it is a very strange arrangement, turning off the toilet on the first floor should only shut off the water to that toilet. It should have no effect on the upstairs shower.
Why won't your snowblower auger blade engage?
possible broken auger belt, or one that has slipped off the pulley
What should you do when your toilet is overflowing?
When your toilet is overflowing, you should immediately turn off the water supply to the toilet by turning the shut-off valve located behind the toilet. Then, try to stop the overflow by using a plunger or a plumbing snake. If the problem persists, contact a plumber for assistance.
