You do not need to run any wires. DSL connects directly to the phone jack. You run phone line from the phone jack to a filter, then to the DSL Modem. You can also install a filter at the interface to eliminate the need for filters inside the home. If you install interior filters, you will need one at each phone jack that is being used by any device. From the modem you can either run USB or Ethernet cable to the computer if the modem is a USB/Ethernet modem. I do not recommend USB. Use the Ethernet if at all possible. The connection is more stable and slightly faster. If your computer has no Ethernet connection, you can install an Ethernet card for as little as $20. Use a good quality Cat5 or Cat6 cable from the Modem to the computer.
You probably have to pay to remove phone wires from your home. The phone company generally is responsible for wires outside the building, while you are responsible for wires inside the building.
Get a HDMI covert or and wires. They sell them at Walmart.com.
cell phones use electricity by the electrical wires outside
The purpose of the thermostat wires outside the AC unit is to connect the thermostat inside the building to the AC unit outside, allowing the thermostat to communicate with the AC unit and control its operation based on the desired temperature settings.
Hot as in electrically charged-yes, they have a small electrical charge to them.
You can connect any wires you want to, but the question I think you're asking is, is it a good idea and will it work? The short answer is: No. The longer answer is: sometimes.
To wire a phone jack correctly, first, strip the outer insulation of the phone cable. Then, connect the colored wires to the corresponding terminals on the phone jack, usually red to red and green to green. Finally, secure the wires in place and test the connection to ensure it is working properly.
Connect the black wire from the switch to the black wires of both lights. Connect the white wires together. Connect the red wire, if used for the motion sensor, to the black wires on the lights. Connect all ground wires together and to the ground terminal on the switch. Make sure to turn off power before connecting any wires for safety.
no they can not.
plug them in
plug them in
Answer why does the person who made a circuit a probably connect the wires to a penny