answersLogoWhite

0

What to use to solder a shut off valve

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Can wet copper pipe be soldiered?

Wet on the surface is no problem, it will evaporate with the torch. If there is water in the pipe, it will not solder because the water keeps the copper from getting hot enough. As long as the water is below the point of solder, it will work. Open the nearest valve or have some way for the steam to get out of the pipe.


What type of solder should be used for copper pipe?

For copper pipe, lead-free solder is recommended to ensure safe and effective connections.


What is the best way to install a copper shut off valve in a plumbing system?

To install a copper shut off valve in a plumbing system, first turn off the water supply. Cut the copper pipe where you want to install the valve using a pipe cutter. Clean the ends of the pipe and the valve with sandpaper. Apply flux to the pipe and valve, then solder them together using a torch. Allow the joint to cool, then turn the water supply back on to test for leaks.


How can I fix a copper pipe?

To fix a copper pipe, you can use a pipe cutter to remove the damaged section, clean the ends of the pipe, and then solder a new piece of copper pipe in place using a propane torch and solder. Be sure to follow proper safety precautions and techniques when working with a torch.


How do you connect copper pipe?

YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints


How do you solder copper to brass fittings?

Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.


What is the average cost to solder a copper pipe?

$135 per hr


How do you properly solder a copper pipe?

To properly solder a copper pipe, first clean the pipe and fitting with emery cloth. Apply flux to both the pipe and fitting, then heat the joint with a propane torch. Once the joint is hot enough, touch the solder to the joint and let it flow around the connection. Allow the joint to cool and wipe away any excess solder.


How do you weld copper pipe to copper pipe - not brazed?

tig or mig depending on the wall thicknessCopper to copper is either soft soldered, or silver solderedSilver solder is a bad term as "solder" normally means lead content according to the AWS


How do you repair a pinhole in copper pipe?

Use a lead-free silver solder. It is the only thing that can handle the pressure and bond with the copper pipe.


How can I repair a copper pipe?

To repair a copper pipe, you can use a pipe cutter to remove the damaged section, clean the ends of the pipe, and then solder a new piece of copper pipe in place using a propane torch and solder. Make sure to follow proper safety precautions and techniques when soldering to ensure a secure and leak-free repair.


What is a sweat inlet?

It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.