answersLogoWhite

0

1 the water level pressure switch broken or clogged.Or the clear hose from the water level switcn is clogged.

To check, remove clear hose from water level switch and blow on switch nipple. If hear a click switch is good, check for clogg on the clear hose to the tank.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is a inlet hose on a washer?

It fills the washer with water from the source, Theres usually a cut-of valve or faucet on the wall near the washer for it.


Should you put clothes in washer before the water fills machine up or after?

before.


When Washer is draining Toilet and Tub fills up with drain water?

You have to use toilet more


Where is the toilet washer?

seal to stop water from runing into tank located between tank and bowk


How does toilet cistern work?

When you pull the handle a washer is lifted and the water goes down into the toilet and at the same time the cistern fills up once the washer is back in place from the flushing mechanism


Why does your Kenmore 70 Series washer not stop filling with water?

There is a clear hose attached to the water level control of the washer. The other end of the hose is attached underneath the washer. The hose isn't attached with any hose clamps so if the washer rocks from a uneven load it could come disconnected and on the next load the water fills up and never stops. Just disconnect the water and electric and the drain and turn the washer on its side look for the hose and reattach it to the hookup underneath-- I just fixed mine, I thought I was going to be buying a new washer but this one still works great now! Hope this helps- Jesse


How do you stop dripping water from taps?

You take the faucet apart and replace the washer and stem seal .


Kenmore washing machine will fill with water and drain off but will not spin water out or wash?

If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.


Does the washer have water in it?

Yes, the washer has water in it.


How does the washing machine work?

The washing machine works by filling with water and rotating. The operator has to put in soap, bleach and softener. The washer agitates, then spins, then fills with water, then rinses by agitating, then drains again by spinning.


Why is there water dripping from the shower faucet?

Water may be dripping from the shower faucet due to a worn-out or faulty washer or seal within the faucet mechanism, causing water to leak through. This can be fixed by replacing the washer or seal to stop the dripping.


How do you stop a toilet tank condensation?

Install a tempering valve in water line feeding toilet. Tempering valve will mix hot and cold water together so warm water fills toilet tank which will stop condensation.