A P trap goes thru the wall, an S trap goes thru the floor.
In plumbing, a trap is a U-, S-, or J-shaped pipe located below or within a plumbing fixture.
The main difference between a p-trap and an s-trap in plumbing systems is their shape and how they prevent sewer gases from entering the building. A p-trap is shaped like the letter "P" and retains water to create a seal, while an s-trap is shaped like the letter "S" and is prone to siphoning, which can break the seal and allow gases to enter.
An S trap is not allowed in a plumbing system. Only a P-Trap
An S-trap and a P-trap are both types of traps used in plumbing systems to prevent sewer gases from entering a building. The main difference between them is their shape and design. An S-trap has a curved pipe that forms an "S" shape, while a P-trap has a curved pipe that forms a "P" shape. P-traps are more commonly used today because they are less likely to siphon dry and allow sewer gases to enter the building.
To convert an S trap to a P trap, you will need to remove the existing S trap and install a new P trap in its place. This involves disconnecting the existing plumbing, removing the S trap, and installing the P trap according to the manufacturer's instructions. It is recommended to consult a professional plumber for this task to ensure proper installation and prevent any potential issues.
To convert an S trap to a P trap in your plumbing system, you will need to remove the existing S trap and install a new P trap in its place. This involves cutting the existing pipe, adding a new trap, and properly connecting the pipes to ensure proper drainage and prevent sewer gas from entering your home. It is recommended to consult a professional plumber for this task to ensure it is done correctly and safely.
An S trap is a type of plumbing trap that is shaped like the letter "S" and is used to prevent sewer gases from entering a building. It differs from other types of traps, such as the P trap, in that it has a curved shape that can lead to siphoning of water, potentially allowing sewer gases to enter the building.
An S trap is a type of plumbing trap that is shaped like the letter "S" and is used to prevent sewer gases from entering a building. It differs from other types of traps, such as the P trap, in that it has a curved shape that can potentially lead to siphoning of water and allow sewer gases to enter the building.
You don't as an S trap is self siphoning thus not allowed in most civilized codes
By cutting it out and installing either a P trap or a running trap as an S trap is notorious for losing its seal
I'm assuming you are talking about a p-trap. A p-trap is a fitting that holds water to block sewer gasses from entering the building through the fixture. Every fixture with a drain has to have one in the waste. A toilet has what you would call an "s-trap" built into it. It serves the same purpose as a p-trap.
building codes in the jurisdiction may require you to use a certain type of trap in certain plumbing designs.A bell trap is used in floor drains (although this particular trap is sometimes erroneously installed in a drainage system).Answers.comAnswers.comAnswers.com. So is a drum trap. S traps are much more common.A p trap is used for sinks