When you flush the toilet, the waste goes either to a septic system if you are in a rural area or a sewage treatment plant if you are in an urban area through pipes in the foundation of the house.
Toilet water may go down slowly or not flush properly due to clogs in the pipes, a malfunctioning flapper or flush valve, or insufficient water pressure. These issues can prevent the proper flow of water needed to effectively flush the toilet.
The toilet water may not go down due to a clog in the pipes, a malfunctioning flush mechanism, or a problem with the water level in the tank.
If the toilet works each time on one flush, they use roughly half the water of a standard toilet. You would then use half as much a month on the toilet. They do not always flush completely on the first flush and the toilet is only a part of the water bill.
both
The toilet may not flush due to a clog in the pipes, a malfunctioning flush mechanism, or insufficient water in the tank.
A water cistern is the part of a toilet that holds water which is then used to flush the toilet.
Yes, it is generally safe to flush toilet paper down the toilet as it is designed to break down easily in water.
The toilet may not flush completely due to a clog in the pipes, a faulty flapper or flush valve, insufficient water pressure, or a problem with the toilet's design.
If the water starts rising after you flush the toilet, you should quickly turn off the water supply to the toilet by twisting the shut-off valve located behind the toilet. This will prevent the toilet from overflowing.
The toilet may not flush properly due to clogs in the pipes, a faulty flapper or flush valve, low water level in the tank, or a problem with the water pressure.
The purpose of the flush on top of a toilet is to release water into the bowl, which helps to remove waste and keep the toilet clean.
To replace a Kohler toilet flush valve, first turn off the water supply to the toilet. Flush the toilet to empty the tank. Remove the tank lid and disconnect the water supply line. Unscrew and remove the old flush valve. Install the new flush valve according to the manufacturer's instructions. Reconnect the water supply line, turn on the water, and test the flush valve for proper operation.