Right below the thermocouple if applicable
There are several possible reasons why your gas water heater pilot light keeps going out. It could be due to a faulty thermocouple, a dirty or clogged pilot light orifice, a draft in the area where the water heater is located, or a problem with the gas supply. It is recommended to have a professional technician inspect and repair the water heater to determine the exact cause of the issue.
The pilot light on your water heater may have gone out due to a variety of reasons, such as a faulty thermocouple, a clogged pilot orifice, a gas supply issue, or a draft in the area where the water heater is located. It is important to troubleshoot and address the specific cause to safely relight the pilot light.
The water heater pilot can go out due to issues such as a faulty thermocouple, a dirty pilot light, or a lack of gas supply.
The pilot light on your water heater may keep going out due to a variety of reasons, such as a dirty or damaged thermocouple, a faulty gas valve, insufficient gas supply, or a draft in the area where the water heater is located. It is important to have a professional inspect and repair the water heater to ensure safe and efficient operation.
The gas water heater pilot light may not stay lit due to a faulty thermocouple, a clogged pilot orifice, insufficient gas flow, or a draft near the pilot light.
A water heater pilot light typically uses about 3-5 cubic feet of gas per day.
The gas water heater pilot may not stay lit due to a faulty thermocouple, a clogged pilot orifice, or a problem with the gas supply. It is important to have a professional inspect and repair the issue to ensure safe and efficient operation of the water heater.
The pilot light on the water heater went out because there was a lack of gas flow or a problem with the ignition system.
To change the gas valve on a water heater, first turn off the gas supply and water heater. Disconnect the gas line and pilot tube from the old valve. Remove the old valve and install the new one in its place. Reconnect the gas line and pilot tube, then turn the gas supply and water heater back on.
Gas water heater has an orifice for main burner and for pilot light, if not electronic ignition.
The pilot light on your hot water heater may keep going out due to a variety of reasons, such as a dirty or damaged pilot light assembly, a faulty thermocouple, insufficient gas supply, or a draft in the area where the water heater is located. It is important to have a professional inspect and repair the issue to ensure safe and efficient operation of your water heater.
To start a gas water heater, first make sure the gas supply is turned on. Then, locate the pilot light and follow the manufacturer's instructions to relight it. Once the pilot light is lit, adjust the temperature setting on the water heater to your desired level. Allow the water heater to heat up the water before using it.