Bofore the question can be answered, it needs to be properly rephrased.
The question contains a grammar error that is all too frequent these days... non-agreement with the subject in number (singular or plural). We need to be more careful of such simple grammar slip-ups. Poor grammar betrays a lack of education and an imprecision of thought.
Correction: Why are telephone wires left slack?
This error is creeping into speech today...from even the news anchors... through the contraction of "is" following the word "there", e.g. "there's too many jobs being lost...".
Correction: There are too many jobs being lost...
scope
to control the position of the implement left or right and to stabilise it stop it from swaying from side to side
A voicemail is an audio recording of a message left by a telephone caller.
In computer networking, "pulling cables" refers to running cables from one point to another (generally through a wall or crawl space, where you feed one end through, then go to the other side and pull them the rest of the way), so "Do not pull those cables" means to not run the specified cables. Often times, pulled cables are left with slack in them so that if components (computers, routers, etc.) need to be moved, you can simply pull ON the cable to gather slack. If, however, the cables have been pulled without slack, then those wires should not be pulled on
The left coil wires go to 1 and 4 the the right coil wires go to 2 and 3.
Red-Ignition Yellow-Battery (memory) Blue-Remote(antenna) Black-Ground Green Wires-Left Rear Purple Wires-Right Rear White Wires-Left Front Grey Wires-Right Front http://forum.ecoustics.com/bbs/messages/4/251407.gif
To allow for expansion and contraction of the metal wire. In the heat of the summer, the wire will expand (lengthen) and will appear to sag between the poles. In the cold of winter, the wire contracts (shortens) and will tighten up between the poles.
Nutty slack is a term used in coal mining to refer to a mixture of different sizes of coal pieces, coal dust, and other impurities that are left over after the larger coal pieces have been extracted. It is considered to be of lower quality compared to pure coal and is usually used for purposes like heating rather than industrial applications.
Zach
you connect it to the THA and E2 wires they ore on the far left in that order the measuring core will be on the left when looking at the plug
if gap is not left between railroads, it will expand in summer and will bend if no space is left
unplug the wires and swap, its very simple. plugs are located on the left side of the engine, to the right of the battery.